Best-guess list of parts for the LACK printer enclosure as built by Zuspiel. Accuracy not guaranteed.
Note: Comes with a wire lead terminal. 60 watts may be overkill.
10Pcs 360V 10A Dual Row Screw Terminals Electric Barrier 12-Position Terminal Strip Block
Note: None
Noctua A-Series Cooling Fan Blades with AAO Frame, SSO2 Bearing (NF-A4x10 FLX) Quantity:3
Note: 40mm fan. Three are used for exhaust. Order one more if also using for Raspberry Pi cooling.
Noctua SSO2 Bearing, Retail Cooling NF-F12 iPPC 2000
Note: 120mm static pressure fan for use in the filter sandwich. Provides high static pressure required to move air through the filter.
Note: Exhaust fan override button. Additional colors are available.
Note: Power switch for lights and exhaust fans. Additional colors are available.
Note: Magnet potentially suitable for the following printed door latch, only order one from this list - https://www.thingiverse.com/thing:21868
Note: Magnet potentially suitable for the following printed door latch, only order one from this list - https://www.thingiverse.com/thing:21868
Magnetic Touch Latch - Black (2 Pk)
Note: Similar latch used by OP. Order if not using the printed door latch.
Note: Similar rubber seal used for enclosure door.
Celtec Expanded PVC Sheet, Satin Smooth Finish, 6mm Thick, 24" Length x 48" Width, Black
Note: Material used for sides and rear walls of enclosure.
Note: Similar or same DC-to-DC buck converter used in the build, but may provide low voltage to Pi under some conditions per Zuspiel's notes.
Note: Alternate DC-to-DC buck converter. Order instead of original GEREE or RioRand units. Uses screw terminals, so additional wiring or soldering skills are not required. Has a power-only USB port, and comes with an enclosure.
Note: Alternate DC-to-DC buck converter. Replaced original GEREE. May require additional wiring and soldering skills to use.
UCTRONICS Ribbon Flat Cable for Raspberry Pi camera 15pin 1.0mm pitch 200cm 6.56ft (Pack of 2)
Note: Pi camera cable. Order whichever is the most appropriate length.
Flex Cable for Raspberry Pi Camera Display (100cm)
Note: Pi camera cable. Order whichever is the most appropriate length.
Raspberry Pi Camera Module V2 - 8 Megapixel,1080p
Note: None
Mudder 8 Piece Black Aluminum Heatsink Cooler Cooling Kit for Raspberry Pi 3, Pi 2, Pi Model B+
Note: None
Enokay DC 5V 0.2A 30mm×30mm×10mm Cooling Fan for Raspberry Pi 2/Pi 3 Case
Note: 30mm fan with pre-installed header for a Raspberry Pi. Do not order if using a 40mm fan instead.
Note: Order if Centigrade temperature read-out is preferred.
Note: Use if Fahrenheit temperature read-out is preferred.
Note: Temp controller for exhaust fans. Similar to controller used by OP, but has dedicated displays for both current and set temperatures.
Electrolux S-Filter H12 Washable HEPA Filter (EL012W)
Note: HEPA filter used in filter sandwich.
Note: Original build lighting strips.