Skip to content

Instantly share code, notes, and snippets.

Embed
What would you like to do?
Let's locate da11 and make the light flash
[dan@r720-01:~] $ sudo sas2ircu list
LSI Corporation SAS2 IR Configuration Utility.
Version 20.00.00.00 (2014.09.18)
Copyright (c) 2008-2014 LSI Corporation. All rights reserved.
Adapter Vendor Device SubSys SubSys
Index Type ID ID Pci Address Ven ID Dev ID
----- ------------ ------ ------ ----------------- ------ ------
0 SAS2008 1000h 72h 00h:42h:00h:00h 1028h 1f1ch
Adapter Vendor Device SubSys SubSys
Index Type ID ID Pci Address Ven ID Dev ID
----- ------------ ------ ------ ----------------- ------ ------
1 SAS2308_2 1000h 87h 00h:43h:00h:00h 1000h 3020h
SAS2IRCU: Utility Completed Successfully.
0 is an internal device
1 is a card I installed because it does IT mode.
[dan@r720-01:~] $ grep mps1 /var/run/dmesg.boot
mps1: <Avago Technologies (LSI) SAS2308> port 0xac00-0xacff mem 0xd1ff0000-0xd1ffffff,0xd1f80000-0xd1fbffff irq 80 at device 0.0 numa-domain 1 on pci18
mps1: Firmware: 20.00.07.00, Driver: 21.02.00.00-fbsd
mps1: IOCCapabilities: 5a85c<ScsiTaskFull,DiagTrace,SnapBuf,EEDP,TransRetry,EventReplay,MSIXIndex,HostDisc>
[dan@r720-01:~] $ grep da11 /var/run/dmesg.boot
da11 at mps1 bus 0 scbus8 target 20 lun 0
da11: <ATA Samsung SSD 850 3B6Q> Fixed Direct Access SPC-4 SCSI device
da11: Serial Number S3PTNF0JA70742A
da11: 600.000MB/s transfers
da11: Command Queueing enabled
da11: 476940MB (976773168 512 byte sectors)
da11: quirks=0x8<4K>
[dan@r720-01:~] $
It appears below on line 180
[dan@r720-01:~] $ sudo sas2ircu 1 display
LSI Corporation SAS2 IR Configuration Utility.
Version 20.00.00.00 (2014.09.18)
Copyright (c) 2008-2014 LSI Corporation. All rights reserved.
Read configuration has been initiated for controller 1
------------------------------------------------------------------------
Controller information
------------------------------------------------------------------------
Controller type : SAS2308_2
BIOS version : 7.39.02.00
Firmware version : 20.00.07.00
Channel description : 1 Serial Attached SCSI
Initiator ID : 0
Maximum physical devices : 1023
Concurrent commands supported : 10240
Slot : 3
Segment : 0
Bus : 67
Device : 0
Function : 0
RAID Support : No
------------------------------------------------------------------------
IR Volume information
------------------------------------------------------------------------
------------------------------------------------------------------------
Physical device information
------------------------------------------------------------------------
Initiator at ID #0
Device is a Hard disk
Enclosure # : 2
Slot # : 0
SAS Address : 5001e82-0-0274-19d2
State : Ready (RDY)
Size (in MB)/(in sectors) : 381554/781422767
Manufacturer : Pliant
Model Number : LB406M
Firmware Revision : D323
Serial No : 41163216tagT3BQ
GUID : N/A
Protocol : SAS
Drive Type : SAS_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 1
SAS Address : 5001e82-0-0275-bf02
State : Ready (RDY)
Size (in MB)/(in sectors) : 381554/781422767
Manufacturer : Pliant
Model Number : LB406M
Firmware Revision : D323
Serial No : 41271040tagT3BQ
GUID : N/A
Protocol : SAS
Drive Type : SAS_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 2
SAS Address : 5001e82-0-0274-1d72
State : Ready (RDY)
Size (in MB)/(in sectors) : 381554/781422767
Manufacturer : Pliant
Model Number : LB406M
Firmware Revision : D323
Serial No : 41164144tagT3BQ
GUID : N/A
Protocol : SAS
Drive Type : SAS_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 3
SAS Address : 5001e82-0-0275-be06
State : Ready (RDY)
Size (in MB)/(in sectors) : 381554/781422767
Manufacturer : Pliant
Model Number : LB406M
Firmware Revision : D323
Serial No : 41270788tagT3BQ
GUID : N/A
Protocol : SAS
Drive Type : SAS_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 4
SAS Address : 5001e82-0-0273-d5e2
State : Ready (RDY)
Size (in MB)/(in sectors) : 381554/781422767
Manufacturer : Pliant
Model Number : LB406M
Firmware Revision : D323
Serial No : 41145824tagT3BQ
GUID : N/A
Protocol : SAS
Drive Type : SAS_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 5
SAS Address : 5001e82-0-0275-9722
State : Ready (RDY)
Size (in MB)/(in sectors) : 381554/781422767
Manufacturer : Pliant
Model Number : LB406M
Firmware Revision : D323
Serial No : 41260832tagT3BQ
GUID : N/A
Protocol : SAS
Drive Type : SAS_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 6
SAS Address : 5001e82-0-0275-98d2
State : Ready (RDY)
Size (in MB)/(in sectors) : 381554/781422767
Manufacturer : Pliant
Model Number : LB406M
Firmware Revision : D323
Serial No : 41261264tagT3BQ
GUID : N/A
Protocol : SAS
Drive Type : SAS_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 7
SAS Address : 5001e82-0-0274-0fde
State : Ready (RDY)
Size (in MB)/(in sectors) : 381554/781422767
Manufacturer : Pliant
Model Number : LB406M
Firmware Revision : D323
Serial No : 41160668tagT3BQ
GUID : N/A
Protocol : SAS
Drive Type : SAS_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 8
SAS Address : 500056b-3-7789-abe4
State : Ready (RDY)
Size (in MB)/(in sectors) : 95396/195371567
Manufacturer : ATA
Model Number : MZ-5EA1000-0D3
Firmware Revision : 7D3Q
Serial No : S0SEN6AD400660
GUID : N/A
Protocol : SATA
Drive Type : SATA_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 9
SAS Address : 500056b-3-7789-abe5
State : Ready (RDY)
Size (in MB)/(in sectors) : 95396/195371567
Manufacturer : ATA
Model Number : MZ-5EA1000-0D3
Firmware Revision : 7D3Q
Serial No : S0SEN6AD400674
GUID : N/A
Protocol : SATA
Drive Type : SATA_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 10
SAS Address : 500056b-3-7789-abe6
State : Ready (RDY)
Size (in MB)/(in sectors) : 476940/976773167
Manufacturer : ATA
Model Number : Samsung SSD 850
Firmware Revision : 3B6Q
Serial No : S3PTNF0JA70742A
GUID : N/A
Protocol : SATA
Drive Type : SATA_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 11
SAS Address : 500056b-3-7789-abe7
State : Ready (RDY)
Size (in MB)/(in sectors) : 476940/976773167
Manufacturer : ATA
Model Number : Samsung SSD 850
Firmware Revision : 3B6Q
Serial No : S3PTNF0JA70159T
GUID : N/A
Protocol : SATA
Drive Type : SATA_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 12
SAS Address : 500056b-3-7789-abe8
State : Ready (RDY)
Size (in MB)/(in sectors) : 476940/976773167
Manufacturer : ATA
Model Number : Samsung SSD 850
Firmware Revision : 3B6Q
Serial No : S3PTNF0JA11513Y
GUID : N/A
Protocol : SATA
Drive Type : SATA_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 13
SAS Address : 500056b-3-7789-abe9
State : Ready (RDY)
Size (in MB)/(in sectors) : 476940/976773167
Manufacturer : ATA
Model Number : Samsung SSD 850
Firmware Revision : 3B6Q
Serial No : S3PTNF0JA70588A
GUID : N/A
Protocol : SATA
Drive Type : SATA_SSD
Device is a Hard disk
Enclosure # : 2
Slot # : 15
SAS Address : 500056b-3-7789-abea
State : Ready (RDY)
Size (in MB)/(in sectors) : 122104/250069679
Manufacturer : ATA
Model Number : Samsung SSD 840
Firmware Revision : 3B0Q
Serial No : S12PNEACB31368P
GUID : N/A
Protocol : SATA
Drive Type : SATA_SSD
Device is a unknown device
Enclosure # : 2
Slot # : 20
SAS Address : 500056b-3-7789-abfd
State : Standby (SBY)
Manufacturer : DP
Model Number : SAS2 EXP BP
Firmware Revision : 1.03
Serial No : x360103
GUID : N/A
Protocol : SAS
Drive Type : SAS_HDD
------------------------------------------------------------------------
Enclosure information
------------------------------------------------------------------------
Enclosure# : 1
Logical ID : 500605b0:06c44fd0
Numslots : 8
StartSlot : 0
Enclosure# : 2
Logical ID : 500056b3:6789abff
Numslots : 38
StartSlot : 0
------------------------------------------------------------------------
SAS2IRCU: Command DISPLAY Completed Successfully.
SAS2IRCU: Utility Completed Successfully.
[dan@r720-01:~] $
[dan@r720-01:~] $ sudo sas2ircu 1 LOCATE 2:10 ON WAIT 20
LSI Corporation SAS2 IR Configuration Utility.
Version 20.00.00.00 (2014.09.18)
Copyright (c) 2008-2014 LSI Corporation. All rights reserved.
SAS2IRCU: IocStatus = 4 IocLogInfo = 824180928
SAS2IRCU: SEP write request failed. Cannot perform LOCATE.
SAS2IRCU: Error executing command LOCATE.
[dan@r720-01:~] $
Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
You can’t perform that action at this time.