View JR_EGRA_PS2_CONTROLLED.ino
//********************************************//
// JUNIOR WITH EGRA //
// PS2 CONTROLLED //
// //
// A complete code to make you controls //
// the robot wirelessly using PS2 controller //
// with built-in UHF STD transmitter paired //
// to UHF STD RX only (Receiver) place on the //
// PBOT JR board. //
// //
View spfd5408_tftpain modified.ino
// Paint example specifically for the TFTLCD breakout board.
// If using the Arduino shield, use the tftpaint_shield.pde sketch instead!
// DOES NOT CURRENTLY WORK ON ARDUINO LEONARDO
// Modified for SPFD5408 Library by Joao Lopes
// Version 0.9.2 - Rotation for Mega
// *** SPFD5408 change -- Begin
#include <SPFD5408_Adafruit_GFX.h> // Core graphics library
#include <SPFD5408_Adafruit_TFTLCD.h> // Hardware-specific library
View Stepper with drivers.ino
/*
e-Gizmo Microstep Driver Sample code
*""""Wiring connections:"""*
Gizduino MCU to Microstep
D3 -------------> DIR
D4 -------------> STP/CLK
GND -------------> GND
+5V -------------> VIN
View 3ch line sensor sample code.ino
/*
eGizmo 3 Channel Line sensor
This is a sample sketch for displaying
the digital output on the serial monitor
of a line sensor.
Codes by
e-Gizmo Mechatronix Central
http://www.e-gizmo.com
View 3ch line sensor sample code.ino
/*
eGizmo 3 Channel Line sensor
This is a sample sketch for displaying
the digital output on the serial monitor
of a line sensor.
Codes by
e-Gizmo Mechatronix Central
http://www.e-gizmo.com
View 5ch line sensor sample code.ino
/*
eGizmo 5 Channel Line sensor
This is a sample sketch for displaying
the digital output on the serial monitor
of a line sensor.
Codes by
e-Gizmo Mechatronix Central
http://www.e-gizmo.com
View GSM TEST using Serial1.ino
/*
GSM Send Sketch for Arduino
Initializes GSM Module and sends an SMS to recipient
The circuit:
*Arduino pin 0 (RX) - GSM Module (TX)
*Arduino pin 1 (TX) - GSM Module (RX)
Created 2010
View BeefySamplecode.ino
/*
e-Gizmo Beefy Motor Driver Sample code
This sketch can simply run your motor in one
direction.
Wiring Connections:
gizDuinoPLUS MCU ===> BeefyMotorDriver
GND ===> GND
RESET ===> RESET
View e-Bot_4x4_Sumobot_with_Line_avoidance.ino
/*
e-Gizmo eBOT 4x4 Sumobot with line avoidance
(with US-100 sensor)
Using State Machine library of Arduino.
For eBOT sample code
I/O Usage
- collision sensor inputs (not used in this demo)
2- colision1 as input
View e-Bot_4x4_Sumobot.ino
/*
e-Gizmo e-Bot 4x4 Sumobot
(with US-100 sensor)
Using State Machine library of Arduino.
For e-BOT sample code
I/O Usage
- collision sensor inputs (not used in this demo)
2- colision1 as input