ersanmaz

Enable systemd in WSL 2

NOTE: If you have Windows 11 there is now an official way to do this in WSL 2, use it if possible - see MS post here (WINDOWS 11 ONLY)

This guide will enable systemd to run as normal under WSL 2. This will enable services like microk8s, docker and many more to just work during a WSL session. Note: this was tested on Windows 10 Build 2004, running Ubuntu 20.04 LTS in WSL 2.

• To enable systemd under WSL we require a tool called systemd-genie

• Copy the contents of install-sg.sh to a new file /tmp/install-sg.sh:

ersanmaz

WSL2 with GUI using Xvnc

In this tutorial, we will setup GUI in WSL2, and access it using VNC. No additional software outside WSL (like VcXsrv) is required, except, of course, a VNC Viewer (RealVNC, TightVNC, TigerVNC, UVNC, etc, all of them might work flawlessly).

The key component we need to install is tigervnc-standalone-server.

For this setup, I will use Ubuntu 20.04 LTS (Focal Fossa, unfortunately 22.04 does not work), and install GNOME Desktop. Since the key components aren't bound to Ubuntu or GNOME, you can use your favorite distro and GUI. Check the Sample screenshots section for examples.

So let's go. First, we need a working WSL2 installation.

ersanmaz

lm-sensors support for it8688E chip (ArchLinux)

0. Make sure you have installed lm_sensors

• sudo pacman -S lm_sensors --needed

1. Download and Install the it87 kernel module for the driver support:

• git clone https://github.com/gamanakis/it87.git --branch=it8688E
• sudo make; sudo make install

2. To temporary enable the it87 module