This is an initiative to create an overview of the issues found with the Creality CR-6 SE.
As of this writing (2020-09-19) the large number of the motherboard issues have not been publicly acknowledged. Hopefully this overview forces Creality to acknowledge the issues with the Creality CR-6 SE leveling free 3d printer.
According to Creality all issues should be resolved in the newer models:
Here are the improvements we did as below:
| ; Ender 3 Custom End G-code | |
| G4 ; Wait | |
| M220 S100 ; Reset Speed factor override percentage to default (100%) | |
| M221 S100 ; Reset Extrude factor override percentage to default (100%) | |
| G91 ; Set coordinates to relative | |
| G1 F1800 E-3 ; Retract filament 3 mm to prevent oozing | |
| G1 F3000 Z20 ; Move Z Axis up 20 mm to allow filament ooze freely | |
| G90 ; Set coordinates to absolute | |
| G1 X0 Y{machine_depth} F1000 ; Move Heat Bed to the front for easy print removal | |
| M106 S0 ; Turn off cooling fan |
| # ======================================================== | |
| # Setup a Dumb AP, Wired backbone for OpenWRT / LEDE | |
| # ======================================================== | |
| # Set lan logical interface as bridge (to allow bridge multiple physical interfaces) | |
| uci set network.lan.type='bridge' | |
| # assign WAN physical interface to LAN (will be available as an additional LAN port now) | |
| uci set network.lan.ifname="$(uci get network.lan.ifname) $(uci get network.wan.ifname)" | |
| uci del network.wan.ifname | |
| # Remove wan logical interface, since we will not need it. | |
| uci del network.wan |