gabonator/esp32_oled_wifi.md

## esp32_oled_wifi.md

      
            Raw
  

              esp32_oled_wifi.md
            
          
    esp32 TTGO arduino compatible board with 128x64 pixel oled display and Wifi


Device description on banggood

The main control chip using Le Xin ESP32, Tensilica LX6 dual core processor, clocked at 240MHz, computing capacity of up to 600DMIPS,
520 SRAM, 802.11 KB chip b/g/n HT40 Wi-Fi transceiver, baseband, and LWIP protocol stack, Bluetooth (Bluetooth dual-mode integrated
traditional and BLE low-power Bluetooth).
onboard 16 Mt bytes (128 Mt bit), Flash, and Wi-Fi antennas
0.96 inch White OLED display
lithium battery charging circuit and interface
CP2102 USB to serial chip, perfect support for Arduino development environment

PCB characteristics
poor rf design, display holding screws too near to wifi antenna (one of them is touching it)
Development tools

board support: arduino-esp32
oled display: ESP8266 and ESP32 Oled Driver for SSD1306 display (directly available from arduino's library manager)

SDA = pin 4, SCL = pin 15, RESET = pin 16
initialize device:

SSD1306 display(0x3c, 4, 15);

pulse RESET signal, or keep it high during startup:

pinMode(16, OUTPUT); 
digitalWrite(16, 1); 

internal led is on pin 2

LED blink sample code
#define LED 2

void setup()
{
  pinMode(LED, OUTPUT);
}

void loop()
{
  digitalWrite(LED, 1);
  delay(1000);
  digitalWrite(LED, 0);
  delay(1000);
}