Created
July 22, 2020 20:56
-
-
Save halmartin/fe4dd24fec2f729c96c544d8f0fcc8a1 to your computer and use it in GitHub Desktop.
MS220 postmerkOS bootlog 2020-07-22
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
LinuxLoader built Nov 12 2002 18:01:50 | |
init_pll ok | |
init_spi ok | |
init_memctl ok | |
wait_memctl ok | |
Training DRAM ok | |
init_irq ok | |
init_dram_uncached ok | |
init_icache ok | |
init_dcache ok | |
enable_caches ok | |
init_board ok | |
Low level initialization complete, exiting boot mode | |
[ 0.000000] Linux version 3.18.123-meraki-elemental (hmartin@alp) (gcc version 5.4.0 (GCC) ) #10 Sat Jul 18 17:06:37 UTC 2020 | |
[ 0.000000] CPU0 revision is: 02019654 (MIPS 24KEc) | |
[ 0.000000] Determined physical RAM map: | |
[ 0.000000] memory: 00477000 @ 00100000 (usable) | |
[ 0.000000] memory: 00049000 @ 00577000 (usable after init) | |
[ 0.000000] User-defined physical RAM map: | |
[ 0.000000] memory: 07ff0000 @ 00000000 (usable) | |
[ 0.000000] Initmem setup node 0 [mem 0x00000000-0x07feffff] | |
[ 0.000000] Reserving 0MB of memory at 0MB for crashkernel | |
[ 0.000000] Kernel command line: console=ttyS0,115200 mtdparts=m25p80:0x40000(redboot),0x2c0000(kernel),0x800000(squashfs),0x500000(overlay) root=/dev/mtdblock3 | |
ubi.mtd=gen_nand.0 mem=134152192 | |
[ 0.000000] PID hash table entries: 512 (order: -1, 2048 bytes) | |
[ 0.000000] Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) | |
[ 0.000000] Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) | |
[ 0.000000] Writing ErrCtl register=80000810 | |
[ 0.000000] Readback ErrCtl register=80000810 | |
[ 0.000000] Cache parity protection enabled | |
[ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 | |
[ 0.000000] NR_IRQS:66 | |
[ 0.000000] sched_clock: 32 bits at 1kHz, resolution 1000000ns, wraps every 2147483648000000ns | |
[ 0.001000] Calibrating delay loop... 275.45 BogoMIPS (lpj=137728) | |
[ 0.010000] pid_max: default: 32768 minimum: 301 | |
[ 0.010000] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes) | |
[ 0.010000] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes) | |
[ 0.012000] ftrace: allocating 11994 entries in 24 pages | |
[ 0.039000] Performance counters: mips/24K PMU enabled, 2 32-bit counters available to each CPU, irq -1 (share with timer interrupt) | |
[ 0.045000] devtmpfs: initialized | |
[ 0.051000] NET: Registered protocol family 16 | |
[ 0.112000] Switched to clocksource MIPS | |
[ 0.139000] NET: Registered protocol family 2 | |
[ 0.141000] TCP established hash table entries: 1024 (order: 0, 4096 bytes) | |
[ 0.141000] TCP bind hash table entries: 1024 (order: 0, 4096 bytes) | |
[ 0.141000] TCP: Hash tables configured (established 1024 bind 1024) | |
[ 0.142000] TCP: reno registered | |
[ 0.142000] UDP hash table entries: 256 (order: 0, 4096 bytes) | |
[ 0.142000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) | |
[ 0.142000] NET: Registered protocol family 1 | |
[ 0.147000] VCORE-III Watchdog Timer enabled (30 seconds). Prev boot was not caused by WDT reset. | |
[ 0.149000] futex hash table entries: 256 (order: -1, 3072 bytes) | |
[ 0.178000] squashfs: version 4.0 (2009/01/31) Phillip Lougher | |
[ 0.178000] jffs2: version 2.2. (NAND) © 2001-2006 Red Hat, Inc. | |
[ 0.180000] msgmni has been set to 241 | |
[ 0.209000] io scheduler noop registered | |
[ 0.209000] io scheduler deadline registered (default) | |
[ 0.211000] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled | |
[ 0.212000] console [ttyS0] disabled | |
[ 0.213000] serial8250.0: ttyS0 at MMIO 0x70100000 (irq = 14, base_baud = 13020833) is a 16550A | |
[ 0.512000] console [ttyS0] enabled | |
[ 0.521000] nand: device found, Manufacturer ID: 0x2c, Chip ID: 0xf1 | |
[ 0.527000] nand: Micron MT29F1G08ABADAWP | |
[ 0.531000] nand: 128MiB, SLC, page size: 2048, OOB size: 64 | |
[ 0.543000] Scanning device for bad blocks | |
[ 0.659000] m25p80 spi0.1: found mx25l12805d, expected m25p80 | |
[ 0.665000] m25p80 spi0.1: mx25l12805d (16384 Kbytes) | |
[ 0.670000] 4 cmdlinepart partitions found on MTD device m25p80 | |
[ 0.676000] Creating 4 MTD partitions on "m25p80": | |
[ 0.681000] 0x000000000000-0x000000040000 : "redboot" | |
[ 0.694000] 0x000000040000-0x000000300000 : "kernel" | |
[ 0.706000] 0x000000300000-0x000000b00000 : "squashfs" | |
[ 0.715000] 0x000000b00000-0x000001000000 : "overlay" | |
[ 0.726000] tun: Universal TUN/TAP device driver, 1.6 | |
[ 0.731000] tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com> | |
[ 0.741000] i2c /dev entries driver | |
[ 0.747000] TCP: cubic registered | |
[ 0.750000] Initializing XFRM netlink socket | |
[ 0.757000] NET: Registered protocol family 10 | |
[ 0.765000] NET: Registered protocol family 17 | |
[ 0.770000] NET: Registered protocol family 15 | |
[ 0.775000] 8021q: 802.1Q VLAN Support v1.8 | |
[ 0.779000] Meraki MS220-8 board detected | |
[ 0.788000] i2c-gpio i2c-gpio.1: using pins 6 (SDA) and 5 (SCL) | |
[ 0.802000] UBI: attaching mtd0 to ubi0 | |
[ 1.602000] UBI: scanning is finished | |
[ 1.638000] UBI: attached mtd0 (name "gen_nand.0", size 128 MiB) to ubi0 | |
[ 1.645000] UBI: PEB size: 131072 bytes (128 KiB), LEB size: 129024 bytes | |
[ 1.652000] UBI: min./max. I/O unit sizes: 2048/2048, sub-page size 512 | |
[ 1.659000] UBI: VID header offset: 512 (aligned 512), data offset: 2048 | |
[ 1.665000] UBI: good PEBs: 1024, bad PEBs: 0, corrupted PEBs: 0 | |
[ 1.671000] UBI: user volume: 12, internal volumes: 1, max. volumes count: 128 | |
[ 1.679000] UBI: max/mean erase counter: 1957/1118, WL threshold: 4096, image sequence number: 1276936678 | |
[ 1.688000] UBI: available PEBs: 462, total reserved PEBs: 562, PEBs reserved for bad PEB handling: 20 | |
[ 1.698000] UBI: background thread "ubi_bgt0d" started, PID 247 | |
[ 1.783000] devtmpfs: mounted | |
[ 1.816000] VFS: Mounted root (squashfs filesystem) readonly on device 31:3. | |
[ 1.860000] devtmpfs: mounted | |
[ 1.868000] Freeing unused kernel memory: 292K | |
[ 5.715000] devpts: called with bogus options | |
Starting syslogd: OK | |
Starting klogd: OK | |
Running sysctl: OK | |
[ 8.631000] random: nonblocking pool is initialized | |
[ 28.679000] jffs2: Cowardly refusing to erase blocks on filesystem with no valid JFFS2 nodes | |
[ 28.688000] jffs2: empty_blocks 0, bad_blocks 0, c->nr_blocks 80 | |
mount: mounting /dev/mtdblock4 on /overlay failed: Input/output error | |
First boot, formatting /overlay | |
0+3 records in | |
0+3 records out | |
board-config is /dev/mtd5 | |
[ 61.126000] vtss_core: module license '(c) Vitesse Semiconductor Inc.' taints kernel. | |
[ 61.134000] Disabling lock debugging due to kernel taint | |
[ 61.757000] switch: 'Meraki MS220-8' board detected | |
Loaded 'luton26/vtss_core.ko board_desc=MERAKI_BOARD_MS220_8' | |
Loaded 'proclikefs.ko' | |
[ 75.841000] click: starting router thread pid 407 (87a81700) | |
Loaded 'merakiclick.ko' | |
Loaded 'elts_meraki.ko' | |
Loaded 'luton26/vc_click.ko' | |
[ 111.091000] chatter: from_sw0 :: FromVitesse: initializing fdma | |
Switch port count: 10 | |
net.ipv4.ip_local_reserved_ports = 50000-50127 | |
sh: Size: unknown operand | |
Waiting for IP address... | |
Waiting for IP address... | |
Waiting for IP address... | |
Waiting for IP address... | |
Waiting for IP address... | |
Waiting for IP address... | |
Waiting for IP address... | |
Using IP address: 192.168.0.21 | |
Saving random seed: SKIP (read-only file system detected) | |
Starting network: OK | |
Starting dhcpcd... | |
/var/db/dhcpcd/duid: Read-only file system | |
DUID 00:03:00:01:88:15:44:27:29:79 | |
arping: IAID 44:27:29:79 | |
sw0_pcap: IAID 02:03:04:05 | |
arping: soliciting a DHCP lease | |
sw0_pcap: soliciting a DHCP lease | |
sw0_pcap: soliciting an IPv6 router | |
arping: soliciting an IPv6 router | |
arping: probing for an IPv4LL address | |
sw0_pcap: probing for an IPv4LL address | |
sw0_pcap: using IPv4LL address 169.254.83.119 | |
sw0_pcap: adding route to 169.254.0.0/16 | |
sw0_pcap: adding default route | |
forked to background, child pid 644 | |
No persistent location to store SSH host keys. New keys will be | |
generated at each boot. Are you sure this is what you want to do? | |
Starting dropbear sshd: OK | |
/ # |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment