Skip to content

Instantly share code, notes, and snippets.

Embed
What would you like to do?
pico-co2-bom.txt
Sensirion SCD30
https://www.mouser.co.uk/ProductDetail/Sensirion/SCD30?qs=rrS6PyfT74fdywu4FxpYjQ%3D%3D
Raspberry Pi Pico (U1)
https://www.raspberrypi.org/products/raspberry-pi-pico/
0.96 OLED SSD1306 (U2)
https://www.amazon.co.uk/SSD1306-Self-Luminous-Display-Compatible-Raspberry-Blue-Yellow/dp/B08FD643VZ/
(other versions are available - make sure the pins are in the order: GND, VCC, SCL, SDA when viewed from the screen
Axial Resistor 330Ohm x 3 (R1, R2, R3)
Axial Resistor 4.7K x 2 (R4, R5)
RGB LED Common Cathode (LED1)
Tactile Switch SPST 6.00mm x 6.00mm (SW1, SW2)
RGB LED and tactile switches from those Arduino parts kits will probably work
Some of these parts are optional. The Sensor and the Pico are required and either the OLED or the LED
are needed show the reading. The switches are not used in in the current code.
Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment