Skip to content

Instantly share code, notes, and snippets.

View shoesandsocks's full-sized avatar

RL Brown shoesandsocks

View GitHub Profile
@shoesandsocks
shoesandsocks / README.md
Created April 26, 2018 14:34 — forked from fasiha/README.md
Set up RTL-SDR, dump1090, and dump978 for ADS-B/TIS-B/FIS-B/UAT on macOS

Introduction

I’m not very familiar with the aviation jargon (see FAA’s ADS-B FAQ), but ADS-B is a next-gen system where aircraft are equipped with transponders that periodically broadcast their own positions and receive the reports from both other aircraft (direct air-to-air) as well as air-traffic control (ATC) ground transmitters.

There are two separate ADS-B radio bands: the commercial aviation (CA) is at 1090 MHz while the general aviation (GA) is at 978 MHz. If I can be permitted a gross generalization—the former corresponds to big commercial jets and the latter to small private aircraft.

Because ADS-B is designed to democratize airspace situational awareness (in contrast to the older setup, like from films, where a central air-traffic controller is coordinating all these aircraft that can’t see each other), we can buy cheap RF receivers to pick up and decode the messages being broadcast by aircraft and ground towers to get our own picture of the

Keybase proof

I hereby claim:

  • I am shoesandsocks on github.
  • I am shoesandsocks (https://keybase.io/shoesandsocks) on keybase.
  • I have a public key whose fingerprint is A1C9 9A65 373D D08E 4BC2 D0B2 680A CC1B B9F6 F96B

To claim this, I am signing this object: