gistfile1.txt

2012-11-21 07:15:50 abetusk: archivist, the picture shows one segment of a whole run.  That one segment has around 70 lines, not 20.  That pattern is repeated again 7 more times on the PCB for a total of around 560 lines or so.  The whole point of the test was to create dashed line in the horizontal and vertical direction and to do them out of order so that I could test what was going on.
2012-11-21 07:16:14 abetusk: This would have been immediately obvious to you had you put it into a gcode interpreter.
2012-11-21 07:21:06 the_wench has left IRC (Ping timeout: 264 seconds)
2012-11-21 07:21:06 archivist has left IRC (Ping timeout: 264 seconds)
2012-11-21 07:34:32 abetusk has left IRC (Quit: Leaving)
2012-11-21 07:34:35 cradek: abetusk: looking at http://imgur.com/cDHrP but have not looked at your gcode.  I suggest checking what happens when you position from the left vs right (test for X backlash) and cut upward vs downward (test for spindle/tool deflection)
2012-11-21 07:34:51 cradek: with randomness it's hard to guess what the problem is
2012-11-21 07:34:57 archivist has joined (~archivist@host81-149-189-98.in-addr.btopenworld.com)
2012-11-21 07:35:23 archivist: damned isp adsl retrains what was my last line
2012-11-21 07:35:47 TekniQue: 09:56:04 < archivist> thing I miss from cnc is the feel of manual