This is unmaintained, please visit Ben-PH/spacemacs-cheatsheet
SPC q q
- quitSPC w /
- split window verticallySPC w
- - split window horizontallySPC 1
- switch to window 1SPC 2
- switch to window 2SPC w c
- delete current window
This is unmaintained, please visit Ben-PH/spacemacs-cheatsheet
SPC q q
- quitSPC w /
- split window verticallySPC w
- - split window horizontallySPC 1
- switch to window 1SPC 2
- switch to window 2SPC w c
- delete current windowNetworkManager supports WiFi powersaving but the function is rather undocumented.
From the source code: wifi.powersave can have the following value:
I am not responsible for any damages, loss of data, system corruption, or any other mishap you may somehow cause by following this guide.
This is mainly a step-by-step reminder/log for myself of how I installed Arch on my laptop. I am putting this out there in case it is useful for someone else, it is not intended to be an official guide. As a result, you may find that this guide is very tedious or lists a lot of unnecessary/intuitive steps or just straight up does things in a way that is considered bad practice. Apart from the latter, this is intentional, as I did not find these steps intuitive at all when
1. Add a virtual serial port to the VM using PVE Web GUI and restart the VM | |
2. Enable and start the virtual serial port on VM, change tty number as needed (Reference: https://askubuntu.com/a/621209/838946) | |
$ sudo systemctl enable serial-getty@ttyS0.service | |
$ sudo systemctl start serial-getty@ttyS0.service | |
3. Done! You can now select xterm.js in the PVE Web GUI |