yuna0x0

1. Add a virtual serial port to the VM using PVE Web GUI and restart the VM

2. Enable and start the virtual serial port on VM, change tty number as needed (Reference: https://askubuntu.com/a/621209/838946)
$ sudo systemctl enable serial-getty@ttyS0.service
$ sudo systemctl start serial-getty@ttyS0.service

3. Done! You can now select xterm.js in the PVE Web GUI

CodingCellist

DISCLAIMER

I am not responsible for any damages, loss of data, system corruption, or any other mishap you may somehow cause by following this guide.

This is mainly a step-by-step reminder/log for myself of how I installed Arch on my laptop. I am putting this out there in case it is useful for someone else, it is not intended to be an official guide. As a result, you may find that this guide is very tedious or lists a lot of unnecessary/intuitive steps or just straight up does things in a way that is considered bad practice. Apart from the latter, this is intentional, as I did not find these steps intuitive at all when

jcberthon

NetworkManager WiFi Power Saving

NetworkManager supports WiFi powersaving but the function is rather undocumented.

From the source code: wifi.powersave can have the following value:

• NM_SETTING_WIRELESS_POWERSAVE_DEFAULT (0): use the default value
• NM_SETTING_WIRELESS_POWERSAVE_IGNORE (1): don't touch existing setting
• NM_SETTING_WIRELESS_POWERSAVE_DISABLE (2): disable powersave

robphoenix

This is unmaintained, please visit Ben-PH/spacemacs-cheatsheet

Useful Spacemacs commands

• SPC q q - quit
• SPC w / - split window vertically
• SPC w - - split window horizontally
• SPC 1 - switch to window 1
• SPC 2 - switch to window 2
• SPC w c - delete current window