aderesh

set number
set ignorecase
syntax on
set belloff=all

":autocmd InsertEnter,InsertLeave * set cul!

aderesh

// sample url: https://github.com/espressif/esp-idf/tree/327c221/examples/peripherals/can/can_self_test
// connect GPIO 21 and GPIO 23 if you don't have a tranciever

///////////////////////

/* CAN Self Test Example

   This example code is in the Public Domain (or CC0 licensed, at your option.)

   Unless required by applicable law or agreed to in writing, this

aderesh

DEV Server

Start DEV server

vault server -dev

Before login

Set vault address before log in

$env:VAULT_ADDR="http://127.0.0.1:8200"

aderesh

Demo env

https://portal.azure.com/#blade/Microsoft_Azure_Monitoring_Logs/DemoLogsBlade

search

search in all columns in 'Perf' table

Perf
| search "Memory"

aderesh

In WD cloud

1. In Settings->Network, turn on NFS Service
2. Go to Shares, and select the Share you would like to use from Raspberry Pi. E.g. Transmission
3. Click on NFS Access
4. Click on configure>>>. For some reason, you have to click on this button
5. You can restrict IP Hosts that can connect and wether a client can drive. Press 'Ok'

In Raspbery PI (ssh)

1. Create your mount folder. E.g. /mnt/nfs
2. sudo mount -t nfs :/nfs/ /mnt/nfs. For instance, sudo mount -t nfs 192.168.0.3:/nfs/Transmission /mnt/nfs

aderesh

CPU over the board: 2.18 mm
Memory: 0.84mm

Switch chip dimensions for heatsink 12mmx18mm

CPU + silicon pad = 2.18 mm + 0.5mm = 2.68 mm. 
2.68 mm is the highest point. Ideally, it should be lower than that because we can squeeze silicon thermal pads up to 2.18

Memory + silicon pad = 2.68mm - 0.84 = 1.84 mm (2mm) of pad needed

aderesh

Controls:

Indicator: is an inidcator around the brew button that is usually green. When descaling is required, the left part of indicator is green and right is part is orange Lid button: can be pressed UP (to open a lid) or DOWN (to shut down the machine, navigate in service mode, etc).

Descaling steps

1. Open the lid and remove any coffee capsule left (LID button UP)
2. Close the lid (LID button DOWN)
3. Fill up the tank and add the descaler (pink liquid)
4. Turn of the machine by pressing the LID button DOWN for 3 seconds. The indicator should be off
5. Press the BREW button and LID DOWN button simulatenously for 3 seconds until indicator becomes solid ORANGE then release. You're in the service mode.

aderesh

# To put into rear brake service mode
Parking break is engaged
Turn the key on
- Disengange the parking brake
Turn the key off

Turn the key and do the following within 8 seconds
- press the brake pedal and hold it
- - engange/pull/up parking brake 3 times
- - release/push/down parking brake 3 times