This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
# This file contains common pin mappings for the 2018 Creality | |
# Ender 3. To use this config, the firmware should be compiled for the | |
# AVR atmega1284p. | |
# Note, a number of Melzi boards are shipped with a bootloader that | |
# requires the following command to flash the board: | |
# avrdude -p atmega1284p -c arduino -b 57600 -P /dev/ttyUSB0 -U out/klipper.elf.hex | |
# If the above command does not work and "make flash" does not work | |
# then one may need to flash a bootloader to the board - see the | |
# Klipper docs/Bootloaders.md file for more information. |