banolka

## ender-3-bl-touch-pin-27.cfg
# This file contains common pin mappings for the 2018 Creality
# Ender 3. To use this config, the firmware should be compiled for the
# AVR atmega1284p.

# Note, a number of Melzi boards are shipped with a bootloader that
# requires the following command to flash the board:
#  avrdude -p atmega1284p -c arduino -b 57600 -P /dev/ttyUSB0 -U out/klipper.elf.hex
# If the above command does not work and "make flash" does not work
# then one may need to flash a bootloader to the board - see the
# Klipper docs/Bootloaders.md file for more information.
	# This file contains common pin mappings for the 2018 Creality
	# Ender 3. To use this config, the firmware should be compiled for the
	# AVR atmega1284p.

	# Note, a number of Melzi boards are shipped with a bootloader that
	# requires the following command to flash the board:
	# avrdude -p atmega1284p -c arduino -b 57600 -P /dev/ttyUSB0 -U out/klipper.elf.hex
	# If the above command does not work and "make flash" does not work
	# then one may need to flash a bootloader to the board - see the
	# Klipper docs/Bootloaders.md file for more information.