jackm

Collection of CAN bus packages and tools

This document assumes the use of Linux as the chosen development platform. Items in bold are highly recommended.

It is recommended to use SocketCAN when working with CAN bus on Linux. It is supported by the Linux kernel mainline and follows the Linux interface model, allowing you to use other network tools such as Wireshark. This also allows the creation of virtual CAN interfaces where no physical hardware is required to simulate or replay CAN messages.

• SocketCAN Linux kernel support - Linux >= 2.6

madkoding

Pairing Bluetooth Devices in Dual Boot with Linux Ubuntu and Windows 10/11

Introduction

This guide provides updated instructions for pairing Bluetooth devices (such as keyboards or mice) in a dual-boot environment with Linux Ubuntu and Windows 10/11, incorporating community feedback and suggestions.

Instructions

1. Pair in Linux First

• Pair your Bluetooth device in Linux. This is crucial to ensure the LinkKey remains consistent.
• Note: Do not re-pair the device in Linux after completing the pairing in Windows.

rgov

# Based on https://github.com/flathub/com.nordpass.NordPass by @FakeShemp

# wget https://raw.githubusercontent.com/flathub/com.nordpass.NordPass/e93574f94b4387917fb8d5b0fb725660b2b01817/gcc10.diff
# wget https://raw.githubusercontent.com/flathub/com.nordpass.NordPass/e93574f94b4387917fb8d5b0fb725660b2b01817/xz_support.patch
# flatpak install flathub org.freedesktop.Platform//22.08 org.freedesktop.Sdk//22.08 org.electronjs.Electron2.BaseApp//22.08
# sudo flatpak-builder --install --force-clean build-dir dev.foxglove.Studio.yaml
# flatpak run dev.foxglove.Studio

app-id: dev.foxglove.Studio
base: org.electronjs.Electron2.BaseApp