danharper

// this is the background code...

// listen for our browerAction to be clicked
chrome.browserAction.onClicked.addListener(function (tab) {
	// for the current tab, inject the "inject.js" file & execute it
	chrome.tabs.executeScript(tab.ib, {
		file: 'inject.js'
	});
});

mitchwongho

# Assuming an Ubuntu Docker image
$ docker run -it <image> /bin/bash

fasiha

Introduction

I’m not very familiar with the aviation jargon (see FAA’s ADS-B FAQ), but ADS-B is a next-gen system where aircraft are equipped with transponders that periodically broadcast their own positions and receive the reports from both other aircraft (direct air-to-air) as well as air-traffic control (ATC) ground transmitters.

There are two separate ADS-B radio bands: the commercial aviation (CA) is at 1090 MHz while the general aviation (GA) is at 978 MHz. If I can be permitted a gross generalization—the former corresponds to big commercial jets and the latter to small private aircraft.

Because ADS-B is designed to democratize airspace situational awareness (in contrast to the older setup, like from films, where a central air-traffic controller is coordinating all these aircraft that can’t see each other), we can buy cheap RF receivers to pick up and decode the messages being broadcast by aircraft and ground towers to get our own picture of the

1duo

Download CMake from: https://cmake.org/download/

wget https://cmake.org/files/v3.12/cmake-3.12.3.tar.gz

Compile from source and install

tar zxvf cmake-3.*