| IOMMU Group 0: | |
| 00:01.0 Host bridge [0600]: Advanced Micro Devices, Inc. [AMD] Starship/Matisse PCIe Dummy Host Bridge [1022:1482] | |
| IOMMU Group 1: | |
| 00:01.1 PCI bridge [0604]: Advanced Micro Devices, Inc. [AMD] Starship/Matisse GPP Bridge [1022:1483] | |
| IOMMU Group 2: | |
| 00:01.3 PCI bridge [0604]: Advanced Micro Devices, Inc. [AMD] Starship/Matisse GPP Bridge [1022:1483] | |
| IOMMU Group 3: | |
| 00:02.0 Host bridge [0600]: Advanced Micro Devices, Inc. [AMD] Starship/Matisse PCIe Dummy Host Bridge [1022:1482] | |
| IOMMU Group 4: | |
| 00:03.0 Host bridge [0600]: Advanced Micro Devices, Inc. [AMD] Starship/Matisse PCIe Dummy Host Bridge [1022:1482] |
| # This file contains pin mappings for the Lulzbot TAZ 6 circa 2020. To | |
| # use this config, the firmware should be compiled for the AVR | |
| # atmega2560. | |
| [stepper_x] | |
| step_pin: PC0 | |
| dir_pin: PL1 | |
| enable_pin: !PA7 | |
| step_distance: .010000 | |
| endstop_pin: ^PB6 |
| # This file contains common pin mappings for the Fysetc Cheetah v1.2b | |
| # board. To use this config, the firmware should be compiled for the | |
| # STM32F103 with "No bootloader" and with "Use USB for communication" | |
| # disabled. | |
| # The "make flash" command does not work on the Cheetah. Instead, | |
| # after running "make", run the following command to flash the board: | |
| # stm32flash -w out/klipper.bin -v -i rts,-dtr,dtr /dev/ttyUSB0 | |
| # See docs/Config_Reference.md for a description of parameters. |
When using the TMC2130 / TMC2209 / TMC2660 / TMC5160 drivers, the StallGuard feature makes it possible to set up sensorless homing on the X and Y axes for CoreXY machines. The Klipper project has a page with documentation and recommendations on getting it working.
Following are some more detailed instructions and suggestions to supplement the Klipper documentation specifically for Vorons.
| [idle_timeout] | |
| timeout: 3600 | |
| [firmware_retraction] | |
| retract_length: 0.40 | |
| retract_speed: 35 | |
| unretract_speed: 25 | |
| #unretract_extra_length: 0.05 | |
| # Tool to help adjust bed leveling screws. One may define a |