dudleyjosh

Once zsh is selected as the default terminal shell:

$ brew update
$ brew install nvm
$ mkdir ~/.nvm (if not already existing)

Then add the following in your ~/.zshrc: 

    export NVM_DIR="$HOME/.nvm"
    source $(brew --prefix nvm)/nvm.sh

dudleyjosh

// I used "Generic Board + WiFi" for my Blynk Project Device Settings
// I added one button setup as a switch mapped to V1 (Blynk Virtual Pin 1) that outputs 0 or 1 to toggle one of the on board LEDs
// I added another button setup as a push button mapped to V0 (Blynk Virtual Pin 0) that outputs 0 or 1 to toggle a Tessel relay

// I had to use --full option when loading the code on the T2 for the blynk-library to run properly

// Example Code Running on Tessel 2
var tessel = require('tessel');

var RelayLib = require('relay-mono');

dudleyjosh

function bit_test(num, bit) {
    return ((num >> bit) % 2 != 0)
}

function bit_set(num, bit) {
    return num | 1 << bit;
}

function bit_clear(num, bit) {
    return num & ~(1 << bit);

dudleyjosh

// #tessel run pins.js T1 or #t2 run pins.js T2
var tesselHardware = process.argv[2] || 'T2';

var tessel = require('tessel');

var PORT_A, PORT_B;

if ( tesselHardware == 'T1' ) {

    PORT_A = {

dudleyjosh

var tessel = require('tessel');
var led = require('tessel-led');
var _ = require('underscore');

// Setup the Relay module on Port A
var relaylib = require('relay-mono');
var relay = relaylib.use(tessel.port['A']);

// Setup all switches & sensors to the GPIO
var gpio = tessel.port['GPIO'];