jasonehines

Routing between two UniFi USG based LANs with ZeroTier

Intro

This is a quick explanation of how to configure both ZeroTier and two Ubiquiti UniFi USGs to allow routing between two IPv4 networks. Both networks are in private (RFC1918) address space and each one has its own DHCP service. There is no need for NAT between them, only IP routing.

The two networks are 192.168.1.0/24 (call this the "left" network) and 192.168.10.0/24 (the "right" network) but they can be anything. Also, you can have multiple CIDR blocks on one side or the other of the ZeroTier route; if you do, you just have to create more routing table entries.

jasonehines

# This file contains pin mappings for the Creality "v4.2.7" board. To
# use this config, during "make menuconfig" select the STM32F103 with
# a "28KiB bootloader" and serial (on USART1 PA10/PA9) communication.

# If you prefer a direct serial connection, in "make menuconfig"
# select "Enable extra low-level configuration options" and select
# serial (on USART3 PB11/PB10), which is broken out on the 10 pin IDC
# cable used for the LCD module as follows:
# 3: Tx, 4: Rx, 9: GND, 10: VCC