mangelajo

Olympus Share APP control urls over E-M10 camera, still to investigate..

http://192.168.0.10
http://192.168.0.10/
http://192.168.0.10/clear_resvflg.cgi
http://192.168.0.10/exec_pwoff.cgi
http://192.168.0.10/exec_shutter.cgi?com=1st2ndpush
http://192.168.0.10/exec_shutter.cgi?com=1stpush
http://192.168.0.10/exec_shutter.cgi?com=1strelease
http://192.168.0.10/exec_shutter.cgi?com=2nd1strelease

rain1024

PdfLatex is a tool that converts Latex sources into PDF. This is specifically very important for researchers, as they use it to publish their findings. It could be installed very easily using Linux terminal, though this seems an annoying task on Windows. Installation commands are given below.

• Install the TexLive base

sudo apt-get install texlive-latex-base

• Also install the recommended and extra fonts to avoid running into the error [1], when trying to use pdflatex on latex files with more fonts.

gbaman

Raspberry Pi Zero OTG Mode

Simple guide for setting up OTG modes on the Raspberry Pi Zero - By Andrew Mulholland (gbaman).

The Raspberry Pi Zero (and model A and A+) support USB On The Go, given the processor is connected directly to the USB port, unlike on the B, B+ or Pi 2 B, which goes via a USB hub.
Because of this, if setup to, the Pi can act as a USB slave instead, providing virtual serial (a terminal), virtual ethernet, virtual mass storage device (pendrive) or even other virtual devices like HID, MIDI, or act as a virtual webcam!
It is important to note that, although the model A and A+ can support being a USB slave, they are missing the ID pin (is tied to ground internally) so are unable to dynamically switch between USB master/slave mode. As such, they default to USB master mode. There is no easy way to change this right now.
It is also important to note, that a USB to UART serial adapter is not needed for any of these guides, as may be documented elsewhere across the int

nstarke

How to make a Release Android App debuggable

Let's say you want to access the application shared preferences in /data/data/com.mypackage.
You could try to run adb shell and then run-as com.mypackage ( or adb shell run-as com.mypackge ls /data/data/com.mypackage/shared_prefs), but on a production release app downloaded from an app store you're most likely to see:

run-as: Package 'com.mypackage' is not debuggable