The following steps shuld be taken to convert the FEIT Electic Smart WiFi Dimmer switch to be cloud-free using the OpenBK7231T software.
WARNING - Modifying electrical equipment that operates at mains power can be dangerous, even deadly, if you you make a mistake. Seek professional help with this conversion if you have any doubts (or should have doubts) in your ability to do it.
Note that this process requires you to have a UART capable of operating at 3.3 volts, some wires to connect the UART to the switch's circuit board, and a computer the UART can conncet to that has Python 3 installed.
Disassemble the switch, removing the circuit board form the switch unit. Be sure not to lose any of the screws or the platstic PCB cover you had to remove. Then, attach 4 wires tyoe the RX1
, TX1
, 3V3
, and GND
points on the circuit board. Also, connected a jumper from the `NRST