nmanzi
/ bigtreetech-skr-2-h2-500c.cfg
Created
January 24, 2023 15:10
Klipper config for the SKR 2 with a Biqu H2 500c Extruder.
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| # This file contains common pin mappings for the BigTreeTech SKR 2. | |
| # To use this config, the firmware should be compiled for the | |
| # STM32F407 with a "32KiB bootloader". | |
| # In newer versions of this board shipped in late 2021 the STM32F429 | |
| # is used, if this is the case compile for this with a "32KiB bootloader" | |
| # You will need to check the chip on your board to identify which you have. | |
| # | |
| # The "make flash" command does not work on the SKR 2. Instead, | |
| # after running "make", copy the generated "out/klipper.bin" file to a |
OlderNewer