jh3y

:root {
    --none: linear(0, 1);
    --power1-in: linear( 0, 0.0039, 0.0156, 0.0352, 0.0625, 0.0977, 0.1407, 0.1914, 0.2499, 0.3164, 0.3906 62.5%, 0.5625, 0.7656, 1 );
    --power1-out: linear( 0, 0.2342, 0.4374, 0.6093 37.49%, 0.6835, 0.7499, 0.8086, 0.8593, 0.9023, 0.9375, 0.9648, 0.9844, 0.9961, 1 );
    --power1-in-out: linear( 0, 0.0027, 0.0106 7.29%, 0.0425, 0.0957, 0.1701 29.16%, 0.2477, 0.3401 41.23%, 0.5982 55.18%, 0.7044 61.56%, 0.7987, 0.875 75%, 0.9297, 0.9687, 0.9922, 1 );
    --power2-in: linear( 0, 0.0014 11.11%, 0.0071 19.24%, 0.0188 26.6%, 0.037 33.33%, 0.0634 39.87%, 0.0978 46.07%, 0.1407 52.02%, 0.1925 57.74%, 0.2559 63.49%, 0.3295 69.07%, 0.4135 74.5%, 0.5083 79.81%, 0.6141 85%, 0.7312 90.09%, 1 );
    --power2-out: linear( 0, 0.2688 9.91%, 0.3859 15%, 0.4917 20.19%, 0.5865 25.5%, 0.6705 30.93%, 0.7441 36.51%, 0.8075 42.26%, 0.8593 47.98%, 0.9022 53.93%, 0.9366 60.13%, 0.963 66.67%, 0.9812 73.4%, 0.9929 80.76%, 0.9986 88.89%, 1 );
    --power2-in-out: linear( 0, 0.0036 9.62%, 0.0185 16.66

ptsgrn

bbbz.org
hmong.wiki
jejekjabar.com
melayukini.net
mocmedia.com.vn
nina.az
nipponkaigi.net
regionkosice.com
siam.wiki
thwiki.press

raulperula

To write the output of a command to a file, there are basically 10 commonly used ways.

Please note that the n.e. in the syntax column means "not existing".
There is a way actually, but it's too complicated to fit into the column. You can find a helpful link in the List section about it.

Overview:

          || visible in terminal ||   visible in file   || existing
  Syntax  ||  StdOut  |  StdErr  ||  StdOut  |  StdErr  ||   file   
==========++==========+==========++==========+==========++===========