(read through this article for a detailed explanation of the steps)
- π room
- minimal ambient noise
- not standing close to hard surfaces (desks, walls, etc)
- not standing in the exact center of the room
- ποΈ microphone
- if you're using a multi-pattern mic like the Blue Yeti, make sure that it is in cardioid (directional) mode:
- π± (smartphone only) know where the microphone is
- on a stand or otherwise held in place
- around chest level, pointed up at your chin at a 45 degree angle
- 5 inches (about a fist with a thumbs up) away from your mouth
- if you're using a multi-pattern mic like the Blue Yeti, make sure that it is in cardioid (directional) mode:
- π΄ recording
- software/app recording settings (detailed instructions for iPhone and Android):
- Format: lossless
.wav
or.aiff
or.flac
.β οΈ Double check this setting!The following lossy formats will not work, and you will have to re-record:
.m4a
,.mp3
,.aac
, etc. - Sample Rate:
48000Hz
/48KHz
(44100Hz
/44.1kHz
is acceptable, but not preferred)π₯οΈ If you're using Audacity, change the default sample rate under
Edit
>Preferences
>Quality
, but also theProject Rate
in the bottom left of the window. - Bit Depth:
24 bit
(16 bit
is acceptable, and the only option on Android) - π± (smartphone only) Microphone selection:
rear/camera
- Turn OFF these settings if present:
limiter
,compression
orautomatic gain control
echo cancellation
ornoise suppression
- Format: lossless
- hardware recording settings:
- set input level/microphone gain correctly
- with level meters: peak at or below
-12dB
- with peak LED: peak adjusted to about
20%
below flashing
- with level meters: peak at or below
- set input level/microphone gain correctly
- software/app recording settings (detailed instructions for iPhone and Android):
- π§ evaluating
- sounds good listening back over headphones
- π« sending
- name your files "
your name
-song title
-voice part (S1/A2/etc)
- sectionverse/part number
taketake number
.wav"
- name your files "
Added a lot more notes as issues have cropped up: