gistfile1.txt

[    0.198639] qcom-pcie 1b500000.pci: supply vdda not found, using dummy regulator
[    0.198853] qcom-pcie 1b500000.pci: supply vdda_phy not found, using dummy regulator
[    0.198961] qcom-pcie 1b500000.pci: supply vdda_refclk not found, using dummy regulator
[    0.199212] qcom-pcie 1b500000.pci: host bridge /soc/pci@1b500000 ranges:
[    0.199301] qcom-pcie 1b500000.pci:       IO 0x000fe00000..0x000fe0ffff -> 0x000fe00000
[    0.199345] qcom-pcie 1b500000.pci:      MEM 0x0008000000..0x000fdfffff -> 0x0008000000
[    0.325401] qcom-pcie 1b500000.pci: iATU unroll: disabled
[    0.325431] qcom-pcie 1b500000.pci: Detected iATU regions: 8 outbound, 8 inbound
[    0.428177] qcom-pcie 1b500000.pci: Link up
[    0.428344] qcom-pcie 1b500000.pci: PCI host bridge to bus 0000:00
[    0.428365] pci_bus 0000:00: root bus resource [bus 00-ff]
[    0.428391] pci_bus 0000:00: root bus resource [io  0x0000-0xffff] (bus address [0xfe00000-0xfe0ffff])
[    0.428410] pci_bus 0000:00: root bus resource [mem 0x08000000-0x0fdfffff]
[    0.428487] pci 0000:00:00.0: [17cb:0101] type 01 class 0x060400
[    0.428627] pci 0000:00:00.0: supports D1
[    0.428646] pci 0000:00:00.0: PME# supported from D0 D1 D3hot
[    0.432951] PCI: bus0: Fast back to back transfers disabled
[    0.433329] pci 0000:01:00.0: [168c:0046] type 00 class 0x028000
[    0.433511] pci 0000:01:00.0: reg 0x10: [mem 0x00000000-0x001fffff 64bit]
[    0.434318] pci 0000:01:00.0: PME# supported from D0 D3hot D3cold
[    0.438569] PCI: bus1: Fast back to back transfers disabled
[    0.438660] pci 0000:00:00.0: BAR 8: assigned [mem 0x08000000-0x081fffff]
[    0.438688] pci 0000:01:00.0: BAR 0: assigned [mem 0x08000000-0x081fffff 64bit]
[    0.438789] pci 0000:00:00.0: PCI bridge to [bus 01-ff]
[    0.438814] pci 0000:00:00.0:   bridge window [mem 0x08000000-0x081fffff]
[    0.439809] pcieport 0000:00:00.0: AER: enabled with IRQ 44
[    0.440598] qcom-pcie 1b700000.pci: supply vdda not found, using dummy regulator
[    0.440819] qcom-pcie 1b700000.pci: supply vdda_phy not found, using dummy regulator
[    0.440928] qcom-pcie 1b700000.pci: supply vdda_refclk not found, using dummy regulator
[    0.441192] qcom-pcie 1b700000.pci: host bridge /soc/pci@1b700000 ranges:
[    0.441285] qcom-pcie 1b700000.pci:       IO 0x0031e00000..0x0031e0ffff -> 0x0031e00000
[    0.441328] qcom-pcie 1b700000.pci:      MEM 0x002e000000..0x0031dfffff -> 0x002e000000
[    0.567162] qcom-pcie 1b700000.pci: iATU unroll: disabled
[    0.567188] qcom-pcie 1b700000.pci: Detected iATU regions: 8 outbound, 8 inbound
[    0.669880] qcom-pcie 1b700000.pci: Link up
[    0.670036] qcom-pcie 1b700000.pci: PCI host bridge to bus 0001:00
[    0.670057] pci_bus 0001:00: root bus resource [bus 00-ff]
[    0.670082] pci_bus 0001:00: root bus resource [io  0x10000-0x1ffff] (bus address [0x31e00000-0x31e0ffff])
[    0.670101] pci_bus 0001:00: root bus resource [mem 0x2e000000-0x31dfffff]
[    0.670168] pci 0001:00:00.0: [17cb:0101] type 01 class 0x060400
[    0.670303] pci 0001:00:00.0: supports D1
[    0.670319] pci 0001:00:00.0: PME# supported from D0 D1 D3hot
[    0.674552] PCI: bus0: Fast back to back transfers disabled
[    0.674933] pci 0001:01:00.0: [168c:0046] type 00 class 0x028000
[    0.675130] pci 0001:01:00.0: reg 0x10: [mem 0x00000000-0x001fffff 64bit]
[    0.676009] pci 0001:01:00.0: PME# supported from D0 D3hot D3cold
[    0.676293] pci 0001:01:00.0: 2.000 Gb/s available PCIe bandwidth, limited by 2.5 GT/s PCIe x1 link at 0001:00:00.0 (capable of 4.000 Gb/s with 5.0 GT/s PCIe x1 link)
[    0.680328] PCI: bus1: Fast back to back transfers disabled
[    0.680412] pci 0001:00:00.0: BAR 8: assigned [mem 0x2e000000-0x2e1fffff]
[    0.680440] pci 0001:01:00.0: BAR 0: assigned [mem 0x2e000000-0x2e1fffff 64bit]
[    0.680544] pci 0001:00:00.0: PCI bridge to [bus 01-ff]
[    0.680568] pci 0001:00:00.0:   bridge window [mem 0x2e000000-0x2e1fffff]
[    0.681424] pcieport 0001:00:00.0: AER: enabled with IRQ 46