ArwedSchmidt

000] IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready
[   31.020000] IPv6: ADDRCONF(NETDEV_UP): br-client: link is not ready
[   31.030000] device br-client entered promiscuous mode
[   31.040000] IPv6: ADDRCONF(NETDEV_UP): local-node: link is not ready
[   32.680000] eth0: link up (100Mbps/Full duplex)
[   32.680000] br-wan: port 1(eth0) entered forwarding state
[   32.690000] br-wan: port 1(eth0) entered forwarding state
[   33.150000] IPv6: ADDRCONF(NETDEV_CHANGE): br-wan: link becomes ready
[   33.510000] batman_adv: bat0: Adding interface: br-wan
[   33.520000] batman_adv: bat0: The MTU of interface br-wan is too small (1500) to handle the transport of batman-adv packets. Packets going over this interface will be fragmented on layer2 which could impact the performance. Setting the MTU to 1532 would solve the problem.

ArwedSchmidt

[   32.380000] batman_adv: bat0: hop_penalty: Changing from: 30 to: 15
[   32.380000] batman_adv: bat0: multicast_mode: Changing from: enabled to: disabled
[   32.410000] batman_adv: bat0: orig_interval: Changing from: 1000 to: 5000
[   34.560000] IPv6: ADDRCONF(NETDEV_UP): client0: link is not ready
[   34.610000] device client0 entered promiscuous mode
[   34.660000] br-client: port 2(client0) entered forwarding state
[   34.660000] br-client: port 2(client0) entered forwarding state
[   34.670000] IPv6: ADDRCONF(NETDEV_CHANGE): client0: link becomes ready
[   34.950000] IPv6: ADDRCONF(NETDEV_UP): ibss0: link is not ready
[   35.000000] ibss0: Created IBSS using preconfigured BSSID 02:ca:ff:ee:e0:54