Configuration for nyquist keyboard

qmk-config-nyquist.md

Nyquist Keyboard mapping

Hardware

• Board: Nyquist rev3
• Switches: Zealios 62g v2
• Caps: DSA blanks
• Case: KPrepublic SP50 case

Key-mapping

{
	"keyboard": "keebio/nyquist/rev3",
	"keymap": "nyquist_custom",
	"layout": "LAYOUT",
	"layers": [
		["KC_GRV", "KC_1", "KC_2", "KC_3", "KC_4", "KC_5", "KC_6", "KC_7", "KC_8", "KC_9", "KC_0", "KC_BSPC", "KC_TAB", "KC_Q", "KC_W", "KC_E", "KC_R", "KC_T", "KC_Y", "KC_U", "KC_I", "KC_O", "KC_P", "KC_DEL", "KC_ESC", "KC_A", "KC_S", "KC_D", "KC_F", "KC_G", "KC_H", "KC_J", "KC_K", "KC_L", "KC_SCLN", "KC_ENT", "KC_LSFT", "KC_Z", "KC_X", "KC_C", "KC_V", "KC_B", "KC_N", "KC_M", "KC_COMM", "KC_DOT", "KC_UP", "KC_RSFT", "KC_LCTL", "KC_LALT", "KC_LGUI", "KC_RALT", "MO(1)", "KC_SPC", "KC_SPC", "MO(1)", "KC_RGUI", "KC_LEFT", "KC_DOWN", "KC_RGHT"],
		["KC_SLEP", "KC_F1", "KC_F2", "KC_F3", "KC_F4", "KC_F5", "KC_F6", "KC_F7", "KC_F8", "KC_MINS", "KC_EQL", "KC_BSPC", "KC_TAB", "KC_F9", "KC_F10", "KC_F11", "KC_F12", "KC_NO", "KC_MSTP", "ANY(KC__VOLUP)", "KC_MPLY", "KC_LBRC", "KC_RBRC", "KC_BSLS", "KC_ESC", "KC_NO", "KC_NO", "KC_NO", "KC_BTN1", "KC_BTN2", "KC_MRWD", "ANY(KC__VOLDOWN)", "KC_MFFD", "KC_SCLN", "KC_QUOT", "KC_ENT", "KC_LSFT", "RGB_MOD", "RGB_RMOD", "RGB_TOG", "KC_SLCK", "KC_PSCR", "KC_NO", "KC_NO", "KC_COMM", "KC_DOT", "KC_SLSH", "KC_RSFT", "KC_LCTL", "KC_LALT", "KC_LGUI", "KC_RALT", "KC_TRNS", "KC_SPC", "KC_SPC", "KC_TRNS", "KC_HOME", "KC_PGDN", "KC_PGUP", "KC_END"]
	]
}

How to flash

• Compile firmware (Either using the configurator or from source)
• Install dfu-programmer from your favorite package manager.
• Place board in flash mode (Press button on bottom of board)
• Erase firmware: dfu-programmer atmega32u4 erase --force
• Flash firmware: dfu-programmer atmega32u4 flash /path/to/firmware.hex
• Reset keyboard: dfu-programmer atmega32u4 reset