GeekVisit

# ------------------------------------------------
# Config files are located in /etc/wireguard/wg0
# ------------------------------------------------

# ---------- Server Config ----------
[Interface]
Address = 10.10.0.1/24 # IPV4 CIDR 
Address = fd86:ea04:1111::1/64 # IPV6 CIDR 
PostUp = iptables -A FORWARD -i wg0 -j ACCEPT; iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADE; ip6tables -A FORWARD -i wg0 -j ACCEPT; ip6tables -t nat -A POSTROUTING -o eth0 -j MASQUERADE # Add forwarding when VPN is started
PostDown = iptables -D FORWARD -i wg0 -j ACCEPT; iptables -t nat -D POSTROUTING -o eth0 -j MASQUERADE; ip6tables -D FORWARD -i wg0 -j ACCEPT; ip6tables -t nat -D POSTROUTING -o eth0 -j MASQUERADE # Remove forwarding when VPN is shutdown

GeekVisit

# /etc/sysctl.d/wireguard.conf
net.ipv4.ip_forward=1
net.ipv6.conf.all.forwarding=1
net.ipv6.conf.default.forwarding=1
net.ipv6.conf.eth0.proxy_ndp=1

#/etc/wireguard/wg0.conf   (DO virtual machine)
[Interface]
# The server interface does not actually need an ipv6.
# The 2 following must be repeated for each used addres [0, 1]

GeekVisit

# WSL2 network port forwarding script v1
#   for enable script, 'Set-ExecutionPolicy -ExecutionPolicy Bypass -Scope CurrentUser' in Powershell,
#   for delete exist rules and ports use 'delete' as parameter, for show ports use 'list' as parameter.
#   written by Daehyuk Ahn, Aug-1-2020

# Display all portproxy information
If ($Args[0] -eq "list") {
    netsh interface portproxy show v4tov4;
    exit;
}