This is a high level, non-exhaustive overview on how to migrate your mod from 1.19.2 to 1.19.3 using Forge.
This primer is licensed under the Creative Commons Attribution 4.0 International, so feel free to use it as a reference and leave a link so that other readers can consume the primer.
If there's any incorrect or missing information, please leave a comment below. Thanks!
The Digilent JTag uses FT2232, but its configuration EEPROM contains secrete data needed to be recoginzed by Xilinx ISE/Vivado. The following method only works on linux (tested on Ubuntu16.04), but the patched FT2232 doggle also works on Windows. Since WSL1 does not provide USB device access, the following method will not work for WSL1.
DONT use FT_Prog on offical Digilent cable, as it can trash the firmware! The offical eeprom contains secrete data that cannot be handled correctly by FT_Prog.
Here are steps to create a Digilent-like Jtag that can be used in Xilinx ISE and Vivado
sudo apt-get install libftdi1 ftdi-eeprom