Toggle Connection to VPN on a Mac via AppleScript

vpn_connection.scpt

tell application "System Events"
	-- get current clipboard contents as a string
	set CurrentClipboard to the clipboard as string
	
	-- set the clipboad to your password	
	set the clipboard to "Y0urVPNPa$$w0rd"
	
	-- start playing with the VPN	
	tell current location of network preferences
		
		-- set the name of the VPN service from your Network Settings
		set VPNService to service "VPN Connection 01"
		-- determine current VPN connection status 	
		set isConnected to connected of current configuration of VPNService
		
		-- if connected, then disconnect	
		if isConnected then
			disconnect VPNService
			
			
		else -- otherwise, connect to the VPN
			
			connect VPNService
			
			-- wait 10 seconds before pasting in the password
			delay 10
			
			tell application id "com.apple.systemevents"
				-- paste clipboard contents into password box
				keystroke "v" using {command down}
				-- press "Enter"
				keystroke (key code 36)
				-- wait 10 seconds to connect	
				delay 10
				-- determine current VPN connection status (after providing password)
				set nowConnected to connected of current configuration of VPNService
				
				-- if we're now connected ...	
				if nowConnected then
					
					-- press "Enter" again to get rid of a dialog confirmation prompt, if one exists
					keystroke (key code 36)
					
					-- now, execute any other commands you want (ping a server to check its status, open mail, etc.)	
					
				end if
			end tell
			
		end if
		
	end tell
	-- now reset the clipboard to what it was before we started
	set the clipboard to CurrentClipboard
end tell

@tuxian0 If you're using the Cisco AnyConnect client then none of this will work. You could try scripting the Cisco client directly, or see if your VPN configuration can be redone with the native macOS VPN client, configured in System Preferences -> Network.

Either this doesn’t work in 10.15 or it doesn’t work with the NordVPN IKE client. Iot doesn’t show up in the scutil —nc list command

@LwsBtlr , this is likely because you are using IKEv2 services. I had a similar issue trying to fix my VPN to auto reconnect. Below is the solution I eventually used. This may point you in the direction to solve your issue:

===
I simply downloaded the precompiled app here.
https://blog.timac.org/2018/0719-vpnstatus/

If you are interested in the source code that makes it work, you can find it on GitHub here: https://github.com/Timac/VPNStatus