adukot

--- gic.c.orig  2014-09-16 16:05:27.000000000 +0000
+++ gic.c       2014-09-16 16:10:54.000000000 +0000
@@ -527,7 +527,7 @@
        bus_space_subregion(sc->sc_memt, mpcaa->mpcaa_memh, mpcaa->mpcaa_off1,
            4096, &sc->sc_gicdh);
        bus_space_subregion(sc->sc_memt, mpcaa->mpcaa_memh, mpcaa->mpcaa_off2,
-           4096, &sc->sc_gicch);
+           256, &sc->sc_gicch);

        sc->sc_gic_type = gicd_read(sc, GICD_TYPER);

adukot

DDR Version 1.00 20121017
In
DDR3
freq
300MHz
config state
pctl
phy
mem

adukot

boot > help
?       - alias for 'help'
askenv  - get environment variables from stdin
base    - print or set address offset
bdinfo  - print Board Info structure
boot    - boot default, i.e., run 'bootcmd'
bootd   - boot default, i.e., run 'bootcmd'
bootelf - Boot from an ELF image in memory
bootm   - boot application image from memory
bootvx  - Boot vxWorks from an ELF image

adukot

boot > fatls mmc 0:7
    59904   ldlinux.sys
      198   syslinux.cfg
  5124544   vmlinuz
   115472   ldlinux.c32

4 file(s), 0 dir(s)
boot > ext4ls mmc 0:4
Failed to mount ext2 filesystem...
** Unrecognized filesystem type **

adukot

00:00.0 Host bridge: Intel Corporation Device 1170 (rev 01)
	Flags: bus master, fast devsel, latency 0

00:01.0 SD Host controller: Intel Corporation Device 1190 (rev 01) (prog-if 01)
	Flags: bus master, fast devsel, latency 64
	Memory at ff3fc000 (32-bit, non-prefetchable) [size=256]
	Capabilities: [b0] Power Management version 3
	Capabilities: [b8] Vendor Specific Information: Len=08 <?>
	Capabilities: [c0] PCI-X non-bridge device

adukot

[    0.000000] Initializing cgroup subsys cpuset
[    0.000000] Initializing cgroup subsys cpu
[    0.000000] Initializing cgroup subsys cpuacct
[    0.000000] Linux version 3.10.17-poky-edison+ (sys_dswci@ncsndgbuild04) (gcc version 4.8.2 (GCC) ) #1 SMP PREEMPT Mon Sep 8 14:09:55 CEST 2014
[    0.000000] e820: BIOS-provided physical RAM map:
[    0.000000] BIOS-e820: [mem 0x0000000000000000-0x0000000000097fff] usable
[    0.000000] BIOS-e820: [mem 0x0000000000100000-0x0000000003ffffff] usable
[    0.000000] BIOS-e820: [mem 0x0000000004000000-0x0000000005ffffff] reserved
[    0.000000] BIOS-e820: [mem 0x0000000006000000-0x000000003f4fffff] usable
[    0.000000] BIOS-e820: [mem 0x000000003f500000-0x000000003fffffff] reserved

adukot

U-Boot 2011.09-rc1 (Jul 03 2013 - 17:40:47) Allwinner Technology

CPU:   SUNXI Family
Board: SUN7I-EVB
DRAM:  1 GiB
NAND:  [NAND] set nand_good_block_ratio 840
3360 MiB
In:    serial
Out:   serial
Err:   serial

adukot

U-Boot 1.1.4-linino-gdd727126 (Mar 19 2014 - 19:37:10)

Linino Board (ar9331) U-boot
DRAM:  64 MB
Top of RAM usable for U-Boot at: 84000000
Reserving 217k for U-Boot at: 83fc8000
Reserving 192k for malloc() at: 83f98000
Reserving 44 Bytes for Board Info at: 83f97fd4
Reserving 36 Bytes for Global Data at: 83f97fb0
Reserving 128k for boot params() at: 83f77fb0

adukot

--- uchcom.c.orig       2015-05-17 07:53:32.000000000 +0000
+++ uchcom.c    2015-05-17 07:59:58.000000000 +0000
@@ -101,7 +101,7 @@

 #define UCHCOM_BRK1_MASK       0x01
 #define UCHCOM_BRK2_MASK       0x40
-
+#if 0
 #define UCHCOM_LCR1_MASK       0xAF
 #define UCHCOM_LCR2_MASK       0x07

adukot

linino> set ipaddr 192.168.0.111
linino> set serverip 192.168.0.9
linino> tftpboot 80020000 netbsd.bin.linino1
dup 1 speed 100
Using eth0 device
TFTP from server 192.168.0.9; our IP address is 192.168.0.111
Filename 'netbsd.bin.linino1'.
Load address: 0x80020000
Loading: #################################################################
         #################################################################