Skip to content

Instantly share code, notes, and snippets.

@aep
Created January 17, 2018 14:49
Show Gist options
  • Save aep/0851b18ca244e7a596aac6fe257b6486 to your computer and use it in GitHub Desktop.
Save aep/0851b18ca244e7a596aac6fe257b6486 to your computer and use it in GitHub Desktop.
[ 0.000000] Linux version 4.4.110 (aep@stark) (gcc version 5.4.0 (LEDE GCC 5.4.0 r3812+1-987a7e3175) ) #0 Wed Jan 17 12:22:43 2018
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU0 revision is: 00019374 (MIPS 24Kc)
[ 0.000000] SoC: Atheros AR9330 rev 1
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 02000000 @ 00000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] No valid device tree found, continuing without
[ 0.000000] Zone ranges:
[ 0.000000] Normal [mem 0x0000000000000000-0x0000000001ffffff]
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x0000000000000000-0x0000000001ffffff]
[ 0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000001ffffff]
[ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
[ 0.000000] Kernel command line: board=TL-HS110 mtdparts=spi0.0:64k(u-boot),3776k(firmware),64k(ART) console=ttyS0,115200 rootfstype=squashfs,jffs2 noinitrd
[ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes)
[ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
[ 0.000000] Writing ErrCtl register=00000000
[ 0.000000] Readback ErrCtl register=00000000
[ 0.000000] Memory: 27612K/32768K available (2988K kernel code, 156K rwdata, 752K rodata, 320K init, 200K bss, 5156K reserved, 0K cma-reserved)
[ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[ 0.000000] NR_IRQS:51
[ 0.000000] Clocks: CPU:400.000MHz, DDR:400.000MHz, AHB:200.000MHz, Ref:25.000MHz
[ 0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 9556302233 ns
[ 0.000013] sched_clock: 32 bits at 200MHz, resolution 5ns, wraps every 10737418237ns
[ 0.007862] Calibrating delay loop... 265.42 BogoMIPS (lpj=1327104)
[ 0.089109] pid_max: default: 32768 minimum: 301
[ 0.093899] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.100327] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.111082] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
[ 0.119478] futex hash table entries: 256 (order: -1, 3072 bytes)
[ 0.126684] NET: Registered protocol family 16
[ 0.131979] MIPS: machine is TP-LINK HS110
[ 0.566137] >>>>>>>>>>> flash base 1000ff0000>>>>>>>>>>> art partition ffffffffffffffff>>>>>>>>>>> with offset ffffffffffffffff
[ 0.631420] clocksource: Switched to clocksource MIPS
[ 0.637052] NET: Registered protocol family 2
[ 0.641102] TCP established hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.646991] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.653296] TCP: Hash tables configured (established 1024 bind 1024)
[ 0.659731] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.665459] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.672027] NET: Registered protocol family 1
[ 0.681916] Crashlog allocated RAM at address 0x1f00000
[ 0.705878] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.710265] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[ 0.723782] io scheduler noop registered
[ 0.726262] io scheduler deadline registered (default)
[ 0.731751] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
[ 0.738372] ar933x-uart: ttyATH0 at MMIO 0x18020000 (irq = 11, base_baud = 1562500) is a AR933X UART
[ 0.750592] m25p80 spi0.0: found mx25l3205d, expected m25p80
[ 0.754916] m25p80 spi0.0: mx25l3205d (4096 Kbytes)
[ 0.759689] 3 cmdlinepart partitions found on MTD device spi0.0
[ 0.765583] Creating 3 MTD partitions on "spi0.0":
[ 0.770346] 0x000000000000-0x000000010000 : "u-boot"
[ 0.778337] 0x000000010000-0x0000003c0000 : "firmware"
[ 0.789411] 2 uimage-fw partitions found on MTD device firmware
[ 0.793971] 0x000000010000-0x000000160000 : "kernel"
[ 0.800930] 0x000000160000-0x0000003c0000 : "rootfs"
[ 0.806719] mtd: device 3 (rootfs) set to be root filesystem
[ 0.810954] 1 squashfs-split partitions found on MTD device rootfs
[ 0.817171] 0x000000330000-0x0000003c0000 : "rootfs_data"
[ 0.824735] 0x0000003c0000-0x0000003d0000 : "ART"
[ 0.847663] libphy: ag71xx_mdio: probed
[ 1.432916] ag71xx-mdio.1: Found an AR7240/AR9330 built-in switch
[ 1.464981] eth0: Atheros AG71xx at 0xba000000, irq 5, mode:GMII
[ 2.053122] ag71xx ag71xx.0: connected to PHY at ag71xx-mdio.1:04 [uid=004dd041, driver=Generic PHY]
[ 2.061895] eth1: Atheros AG71xx at 0xb9000000, irq 4, mode:MII
[ 2.069988] NET: Registered protocol family 10
[ 2.078470] NET: Registered protocol family 17
[ 2.081652] bridge: automatic filtering via arp/ip/ip6tables has been deprecated. Update your scripts to load br_netfilter if you need this.
[ 2.094262] 8021q: 802.1Q VLAN Support v1.8
Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment