Newer Patch for Archer C5 v4

981213.git-b8db4ad0bc572974cbe3b5cf47287f1bb37c218b 2.patch

From b8db4ad0bc572974cbe3b5cf47287f1bb37c218b Mon Sep 17 00:00:00 2001 From: DENG Qingfang dengqf6@mail2.sysu.edu.cn Date: Mon, 18 May 2020 16:38:12 +0800 Subject: [PATCH] ramips: add support for TP-Link Archer C5 v4

TP-Link Archer C5 v4 is a dual band router with 5 GbE ports Advertised as AC1200 for its 867Mbps (2x2) 5GHz band and 300 Mbps (2x2) 2.4GHz band.

Specs:

SoC: MediaTek MT7620A
Ethernet: 5x GbE ports (Realtek RTL8367S)
Wireless 2.4GHz: MediaTek MT7620A
Wireless 5GHz: MediaTek MT7612E
RAM: 64MiB
ROM: 8MiB (GD25Q64CSIG)
1 USB 2.0 port
2 Buttons (WPS and reset)
8 LEDs
Flash instructions: Currently one has to install OpenWrt only via the serial console

Rename the factory.bin to to test.bin
start a TFTP server from IP address 192.168.0.225 and serve the image named test.bin
connect your device to the LAN port
power up the router and press 4 on the console to stop the boot process.
enter the following commands on the router console tftp 0x80060000 test.bin erase tplink 0x20000 0x7a0000 cp.b 0x80060000 0x20000 0x7a0000 reset
Signed-off-by: DENG Qingfang dengqf6@mail2.sysu.edu.cn

.../dts/mt7620a_tplink_archer-c5-v4.dts | 204 ++++++++++++++++++ target/linux/ramips/image/mt7620.mk | 16 ++ .../mt7620/base-files/etc/board.d/01_leds | 4 + .../mt7620/base-files/etc/board.d/02_network | 7 + 4 files changed, 231 insertions(+) create mode 100644 target/linux/ramips/dts/mt7620a_tplink_archer-c5-v4.dts

diff --git a/target/linux/ramips/dts/mt7620a_tplink_archer-c5-v4.dts b/target/linux/ramips/dts/mt7620a_tplink_archer-c5-v4.dts new file mode 100644 index 0000000000..0c61969a64 - /dev/null + b/target/linux/ramips/dts/mt7620a_tplink_archer-c5-v4.dts @@ -0,0 +1,204 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include "mt7620a.dtsi" + +#include <dt-bindings/input/input.h> +#include <dt-bindings/gpio/gpio.h> + +/ {

compatible = "tplink,archer-c5-v4", "ralink,mt7620a-soc";
model = "TP-Link Archer C5 v4";
aliases {
led-boot = &led_power;
led-failsafe = &led_power;
led-running = &led_power;
led-upgrade = &led_power;
label-mac-device = ðernet;
};
chosen {
bootargs = "console=ttyS0,115200";
};
leds {
compatible = "gpio-leds";
led_power: power {
label = "archer-c5-v4:green:power";
gpios = <&gpio2 2 GPIO_ACTIVE_LOW>;
};
wlan2g {
label = "archer-c5-v4:green:wlan2g";
gpios = <&gpio0 14 GPIO_ACTIVE_LOW>;
linux,default-trigger = "phy1tpt";
};
wlan5g {
label = "archer-c5-v4:green:wlan5g";
gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
linux,default-trigger = "phy0tpt";
};
wan {
label = "archer-c5-v4:green:wan";
gpios = <&gpio0 10 GPIO_ACTIVE_LOW>;
};
wan_orange {
label = "archer-c5-v4:orange:wan";
gpios = <&gpio0 9 GPIO_ACTIVE_LOW>;
};
lan {
label = "archer-c5-v4:green:lan";
gpios = <&gpio0 8 GPIO_ACTIVE_HIGH>;
};
usb {
label = "archer-c5-v4:green:usb";
gpios = <&gpio0 7 GPIO_ACTIVE_LOW>;
trigger-sources = <&ohci_port1>, <&ehci_port1>;
linux,default-trigger = "usbport";
};
wps {
label = "archer-c5-v4:green:wps";
gpios = <&gpio0 1 GPIO_ACTIVE_LOW>;
};
};
keys {
compatible = "gpio-keys";
reset {
label = "reset";
gpios = <&gpio0 13 GPIO_ACTIVE_LOW>;
linux,code = <KEY_RESTART>;
};
rfkill {
label = "rfkill";
gpios = <&gpio0 2 GPIO_ACTIVE_LOW>;
linux,code = <KEY_RFKILL>;
};
};
rtl8367s {
compatible = "realtek,rtl8367c";
cpu_port = <7>;
realtek,extif2 = <1 0 1 1 1 1 1 1 2>;
mii-bus = <&mdio0>;
phy-id = <29>;
}; +};
+&gpio2 {
status = "okay"; +};
+&spi0 {
status = "okay";
flash@0 {
compatible = "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <60000000>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "u-boot";
reg = <0x0 0x20000>;
read-only;
};
partition@20000 {
compatible = "tplink,firmware";
label = "firmware";
reg = <0x20000 0x7a0000>;
};
partition@7c0000 {
label = "config";
reg = <0x7c0000 0x10000>;
read-only;
};
rom: partition@7d0000 {
label = "rom";
reg = <0x7d0000 0x10000>;
read-only;
};
partition@7e0000 {
label = "romfile";
reg = <0x7e0000 0x10000>;
read-only;
};
radio: partition@7f0000 {
label = "radio";
reg = <0x7f0000 0x10000>;
read-only;
};
};
}; +};
+&state_default {
gpio {
groups = "i2c", "uartf", "ephy", "rgmii2";
function = "gpio";
}; +};
+&ethernet {
pinctrl-names = "default";
mtd-mac-address = <&rom 0xf100>;
pinctrl-0 = <&rgmii1_pins &mdio_pins>;
port@5 {
status = "okay";
mediatek,fixed-link = <1000 1 1 1>;
phy-mode = "rgmii";
};
mdio0: mdio-bus {
status = "okay";
reset-gpios = <&gpio2 20 GPIO_ACTIVE_LOW>;
reset-delay-us = <10000>;
}; +};
+&ehci {
status = "okay"; +};
+&ohci {
status = "okay"; +};
+&wmac {
ralink,mtd-eeprom = <&radio 0>;
mtd-mac-address = <&rom 0xf100>; +};
+&pcie {
status = "okay"; +};
+&pcie0 {
wifi@0,0 {
reg = <0x0000 0 0 0 0>;
mediatek,mtd-eeprom = <&radio 0x8000>;
ieee80211-freq-limit = <5000000 6000000>;
mtd-mac-address = <&rom 0xf100>;
mtd-mac-address-increment = <2>;
}; +}; diff --git a/target/linux/ramips/image/mt7620.mk b/target/linux/ramips/image/mt7620.mk index d9725c9e69..cda58ea708 100644 - a/target/linux/ramips/image/mt7620.mk + b/target/linux/ramips/image/mt7620.mk @@ -1003,6 +1003,22 @@ define Device/tplink_archer-c2-v1 endef TARGET_DEVICES += tplink_archer-c2-v1
+define Device/tplink_archer-c5-v4

$(Device/tplink-v2)
SOC := mt7620a
IMAGE_SIZE := 7808k
TPLINK_FLASHLAYOUT := 8Mmtk
TPLINK_HWID := 0x04DA857C
TPLINK_HWREV := 0x0C000600
TPLINK_HWREVADD := 0x04000000
IMAGES += tftp-recovery.bin
IMAGE/tftp-recovery.bin := pad-extra 128k | $$(IMAGE/factory.bin)
DEVICE_MODEL := Archer C5
DEVICE_VARIANT := v4
DEVICE_PACKAGES := kmod-usb2 kmod-usb-ohci kmod-usb-ledtrig-usbport kmod-mt76x2 kmod-switch-rtl8367b +endef +TARGET_DEVICES += tplink_archer-c5-v4
define Device/tplink_archer-c50-v1 $(Device/tplink-v2) SOC := mt7620a diff --git a/target/linux/ramips/mt7620/base-files/etc/board.d/01_leds b/target/linux/ramips/mt7620/base-files/etc/board.d/01_leds index ec86ed4b3f..fe61026255 100755 - a/target/linux/ramips/mt7620/base-files/etc/board.d/01_leds + b/target/linux/ramips/mt7620/base-files/etc/board.d/01_leds @@ -194,6 +194,10 @@ tplink,archer-c20i) ucidef_set_led_switch "lan" "lan" "$boardname:blue:lan" "switch0" "0x1e" ucidef_set_led_switch "wan" "wan" "$boardname:blue:wan" "switch0" "0x01" ;; +tplink,archer-c5-v4)
ucidef_set_led_switch "lan" "lan" "$boardname:green:lan" "switch1" "0x0f"
ucidef_set_led_switch "wan" "wan" "$boardname:green:wan" "switch1" "0x10"
;; tplink,archer-c50-v1) ucidef_set_led_switch "lan" "lan" "$boardname:green:lan" "switch0" "0x1e" ucidef_set_led_switch "wan" "wan" "$boardname:green:wan" "switch0" "0x01" diff --git a/target/linux/ramips/mt7620/base-files/etc/board.d/02_network b/target/linux/ramips/mt7620/base-files/etc/board.d/02_network index 3fdd42bbff..38b4ad03d9 100755 - a/target/linux/ramips/mt7620/base-files/etc/board.d/02_network + b/target/linux/ramips/mt7620/base-files/etc/board.d/02_network @@ -207,6 +207,12 @@ ramips_setup_interfaces() ucidef_add_switch "switch0"
"1:lan:3" "2:lan:4" "3:lan:1" "4:lan:2" "0:wan" "6@eth0" ;;
tplink,archer-c5-v4)
ucidef_add_switch "switch0"
ucidef_add_switch_attr "switch0" "enable" "0"
ucidef_add_switch "switch1"
"0:lan:4" "1:lan:3" "2:lan:2" "3:lan:1" "4:wan" "7@eth0"
;; tplink,archer-mr200) ucidef_add_switch "switch0"
"0:lan" "1:lan" "2:lan" "3:lan" "6t@eth0" @@ -347,6 +353,7 @@ ramips_setup_macs() tplink,archer-c2-v1|
tplink,archer-c20-v1|
tplink,archer-c20i|
tplink,archer-c5-v4|
tplink,archer-c50-v1|
tplink,archer-mr200) wan_mac=\((macaddr_add "\)(mtd_get_mac_binary rom 0xf100)" 1)
2.30.2