———————————————————
>>>СКАЧАТЬ<<<
———————————————————
Download link
———————————————————
Код ошибки p1500
If the PCM does Код ошибки p1500 see low voltage when the switch is ON a DTC will set. P1506 — Idle Air Control IAC Overspeed Error This DTC is set when the PCM detects engine idle speed that is greater than the desired rpm. The test fails when the signal on the monitor pin is outside an expected calibrated range. One or both inputs to the PCM did not change when it was expected to. If the PCM does not see low voltage when the switch is on a DTC will set. Сброса ошибок хватает максимум на 1 км. DTCs stored in a secondary module, which requested the MIL to be turned on. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. С другой стороны у Renault на все ошибки есть свои более точные расшифровки, лучше подключать нормальный мультимарочный сканер или Clip. IAC circuit open VPWR to IAC solenoid open IAC circuit short to PWR IAC circuit short to GND Damaged IAC valve Damaged PCM The IAC solenoid resistance is from 6 to 13 ohms. The test fails when the signal on the monitor pin is more than an expected calibrated range with IMRC activated. Intermittent VSS connections Intermittent open in VSS harness circuit s Intermittent short in VSS harness circuit s Damaged VSS Damaged PCM P1501 — Vehicle Speed Sensor VSS Код ошибки p1500 of Self Test Range Indicates the VSS input signal is out of Self Test range.
P1502 — Vehicle Speed Sensor VSS Intermittent Indicates the powertrain control module PCM detected an error in the vehicle speed information. Двигатель после прогрева работает не ровно. This DTC is set the same way as P0500. P1502 — Vehicle Speed Sensor VSS Intermittent TCIL illuminates Indicates the powertrain control module PCM detected an error in the vehicle speed information. This DTC is set when a VSS fault interferes with other OBDII tests, such as Catalyst efficiency monitor, EVAP monitor, HO2S monitor, etc.
The test fails when the signal on the monitor pin is outside an expected calibrated range. С другой стороны у Renault на все ошибки есть свои более точные расшифровки, лучше подключать нормальный мультимарочный сканер или Clip. This DTC is set the same way as Код ошибки p1500. IAC circuit open IAC circuit short to PWR VPWR to IAC solenoid open Air inlet is plugged Damaged IAC solenoid Damaged PCM The IAC solenoid resistance is from 6 to 13 ohms Disconnect IAC valve and look for no change in engine rpm as an indication of a stuck or damaged valve P1516 — Intake Manifold Runner Control Input Error Bank 1 P1517 — Intake Manifold Runner Control Input Error Bank 2 The IMRC system is monitored for failure during continuous or key ON engine OFF self-test. This DTC is set when a VSS fault interferes with other OBDII tests, such as Catalyst efficiency monitor, EVAP monitor, HO2S monitor, etc. However there are external items that can cause this DTC. Подскажите пожалуйста в чем может быть причина.
Код ошибки p1500
P1506 — Idle Air Control IAC Overspeed Error This DTC is set when the PCM detects engine idle speed that is greater than the desired rpm. See DTC P2004 P2006 — Variable tumble control system VTCS shutter valve stuck closed ON 2 CCM. P1605 — Keep Alive Memory Test Failure Indicates the PCM has experienced an internal memory test failure. This DTC is set when a VSS fault interferes with other OBDII tests, such as Catalyst efficiency monitor, EVAP monitor, HO2S monitor, etc.
В вашем браузере отключены файлы cookies. Чтобы включить cookies, воспользуйтесь советами на.