Create a gist now

Instantly share code, notes, and snippets.

esp8266-smart-config
#include <ESP8266WiFi.h>
#include <WiFiUdp.h>
void setup() {
int cnt = 0;
// set for STA mode
WiFi.mode(WIFI_STA);
// put your setup code here, to run once:
Serial.begin(9600);
// led status at pin16
pinMode(16,OUTPUT);
//configure pin0
pinMode(0, INPUT_PULLUP);
// deplay for 2 sec for smartConfig
Serial.println("2 sec before clear SmartConfig");
delay(2000);
// read pullup
int isSmartConfig = digitalRead(0);
if (isSmartConfig==0) {
// bink for clear config
blinkClearConfig();
Serial.println("clear config");
// reset default config
WiFi.disconnect();
}
// if wifi cannot connect start smartconfig
while(WiFi.status() != WL_CONNECTED) {
delay(500);
Serial.print(".");
if(cnt++ >= 15){
WiFi.beginSmartConfig();
while(1){
delay(500);
if(WiFi.smartConfigDone()){
Serial.println("SmartConfig Success");
blinkSmartConfig();
break;
}
}
}
}
Serial.println("");
Serial.println("");
WiFi.printDiag(Serial);
// Print the IP address
Serial.println(WiFi.localIP());
}
void blinkSmartConfig() {
digitalWrite(16, HIGH); // turn the LED on (HIGH is the voltage level)
delay(50); // wait for a second
digitalWrite(16, LOW); // turn the LED off by making the voltage LOW
delay(50);
}
void blinkClearConfig() {
int i=0;
while(i<=3) {
digitalWrite(16, HIGH); // turn the LED on (HIGH is the voltage level)
delay(100); // wait for a second
digitalWrite(16, LOW); // turn the LED off by making the voltage LOW
delay(100);
i++;
}
}
void blinkStartConfig() {
pinMode(16,OUTPUT);
int i=0;
digitalWrite(16, HIGH); // turn the LED on (HIGH is the voltage level)
}
void loop() {
}
Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment