Andrew atomspring

## AP230 Client.md

      
              1 file
            
          
              1 fork
            
          
              0 comments
            
          
              1 star
            
          
                atomspring
                / AP230 Client.md
            
            
              Last active
              September 13, 2023 19:27
            
              
                Aerohive AP230 wireless client bridge
              
          
    AP230 Wireless Client Bridge Setup

This is a quick guide to setting up your AP230 as a wireless client bridge, allowing any devices plugged in via eth0 to communicate with the network of the connected SSID.
Note that this config uses NAT, and I cannot figure out how to set a static IP for the "WAN" interface, so DHCP it is.
Setup steps


Connect a console cable to to the "console" port (or do step two, SSH into the address which appears on your network)
After providing power to the AP (either with PoE or 12v/1a connector), hold the reset button for 30s (or login and execute reset config bootstrap, reset config)
Default login: admin:aerohive
Basic Administravia: