Quick test for latest Arduino based Blinks API

Blinks Send and Receive Test

/*  Blinks Send/Receive (Test)
 *  
 *  --------------------------------------------------------------------------------------------------
 *  IMPORTANT: To use this code in Arduino's IDE, first move the Move38-Blinks folder
 *  into the right directory i.e. <user home directory>/Documents/Arduino/hardware/Move38-Blinks
 *  Then open the Arduino IDE and select Tools > Board > "Move38-Blinks"
 *  Now you should be good to go :) (thanks to the hard work of Josh Levine – josh.com)
 *  -------------------------------------------------------------------------------------------------- 
 *     
 *  by Jonathan Bobrow
 *  www.Move38.com
 *  08.29.2017
 */

uint8_t colors[4][3] = {{255,0,0},        // Red
                   {0,255,0},         // Green
                   {0,0,255},         // Blue
                   {255,255,0}};      // Yellow


int isSending = 0; // 0 for receive mode, 1,2,3 for receive mode

int neighbors[6] = {0,0,0,0,0,0};

void setup() {
  // put your setup code here, to run once:

  // animate red circle to show reset or startup
  for(int i=0; i<FACE_COUNT; i++) {
        setPixelRGB(i,200,0,0);
        delay(100);
        setAllRGB(0,0,0);        // Show pixels one at a time, and leave display clear when circle finished
  }
}

void loop() {

    // switch through 4 modes ( 0 = receive, 1,2,3 = sending 1,2,or 3 )
    if(buttonPressed()) {
      isSending = (isSending + 1) % 4;
    }
    
    if(isSending) {

      // get neighbor states
      for(int i=0; i<FACE_COUNT; i++) {

        // send value 1,2, or 3 on every face depending on our state
        irSendDibit(i,isSending);

        // show which value is being sent by diplaying color
        setPixelRGB(
                  i,
                  colors[isSending][0],
                  colors[isSending][1],
                  colors[isSending][2]
        );
      }
      
    }
    else {
      // receiving
      
      // set all sides to dark
      // setAllRGB(0,0,0);

      // get neighbor states
      for(int i=0; i<FACE_COUNT; i++) {

        // check if IR message is available
        if(irIsAvailable(i)) {

          // get value read on face
          int val = irReadDibit(i);
          
          // save value read on face... not in use
          neighbors[i] = val;

          // set side to the color of the received information
          setPixelRGB( i,
                       colors[val][0],
                       colors[val][1],
                       colors[val][2]);
        }
      }

      delay(100);     // Let the displayed color stay on long enough for at least one frame so actually visible. 

      setAllRGB( 0 , 0 , 0 );     // Clear display for next round!
    }
}