nerdalert

Geneve tunnels using netlink examples

Scenario A - pointing to an interface as the next hop

Host A configuration (eth0 - 192.168.1.191):

# Remote Address is the IP of Host B eth0
sudo ip link add name geneve0 type geneve id 1000 remote 192.168.1.192
sudo ip link set geneve0 up
sudo ip addr add 10.200.1.1/32 dev geneve0

willsthompson

SACD Ripping

Prerequisites

1. Firmware-compatible Bluray/SACD player. See threads below:

   • https://www.quadraphonicquad.com/forums/threads/sony-blu-ray-players-used-for-sacd-ripping.26078/
   • https://hifihaven.org/index.php?threads/rip-sacd-with-a-blu-ray-player.3652/#post-69000

2. AutoScript files. These will root the player and allow raw read access over a network.

kentonv

As tested on Linux:

• An SCM_RIGHTS ancillary message is "attached" to the range of data bytes sent in the same sendmsg() call.
• However, as always, recvmsg() calls on the receiving end don't necessarily map 1:1 to sendmsg() calls. Messages can be coalesced or split.
• The recvmsg() call that receives the first byte of the ancillary message's byte range also receives the ancillary message itself.
• To prevent multiple ancillary messages being delivered

steve-jansen

This script enables you stop and start Symantec Endpoint Protection on OS X

Installation

sudo curl https://gist.githubusercontent.com/steve-jansen/61a189b6ab961a517f68/raw/sep -o /usr/local/bin/sep
sudo chmod 755 /usr/local/bin/sep
sudo chown root:staff /usr/local/bin/sep