ndfred

⚠️ There is now an official way to connect Glow to Home Assistant via MQTT, I would suggest using that instead of the method described below. Here are the sensor templates for that (replace GLOW_DEVICE_ID with the relevant information for your device):

mqtt:
  sensor:
    - name: "Home Power"
      state_topic: "glow/GLOW_DEVICE_ID/SENSOR/electricitymeter"
      unit_of_measurement: 'W'
      value_template: "{{ (value_json['electricitymeter']['power']['value'] * 1000) | int }}"
      icon: 'mdi:flash'

bedros

My Darktable Workflow

Basic workflow

• Copy a film roll (a directory of RAW images) into a directory on the machine running Darktable.
• Import the film roll into Darktable.
• Review the images using lighttable mode and remove any images that are beyond repair.
• Take a snapshot of the image so we can do a before and after comparison.
• Adjust the white balance.
• Exposure compensation and recovery.

eimajtrebor

My Darktable Workflow

Basic workflow

• Copy a film roll (a directory of RAW images) into a directory on the machine running Darktable.
• Import the film roll into Darktable.
• Review the images using lighttable mode and remove any images that are beyond repair.
• Take a snapshot of the image so we can do a before and after comparison.
• Adjust the white balance.
• Exposure compensation and recovery.