ChipCE

READ THIS FIRST

Adaptive bed mesh is merged into klipper master branch. You can use this feature without this custom macro. Official klipper adaptive bed mesh

Klipper mesh on print area only install guide

What this macro do

• This macro will dynamically changing the bed mesh area based on the size of the parts will be printed. The fw will only probe on the area that the part will be printed (plus mesh_area_offset value)

SamuelGulas

/// *****        © ShopVacSwitch        ***** ///
///      Automated Vacuum Cleaner Switch      ///
///      Current sensor type: ACS 712-30      ///
///                                           ///
///         Last updated on 1/20/21           ///
///                                           ///
/// *****         Code by Jacob.        ***** ///


#define SAMPLES 300

Biacco42

# This file contains pin mappings for the Anycubic i3 Mega with
# Ultrabase from 2017. (This config may work on an Anycubic i3 Mega v1
# prior to the Ultrabase if you comment out the definition of the
# endstop_pin in the stepper_z1 section.) To use this config, the
# firmware should be compiled for the AVR atmega2560.

# See the example.cfg file for a description of available parameters.

[stepper_x]
step_pin: ar54