mihaiserban

# This file contains pin mappings for the Creality Ender 5 Plus.
# Ender 5 Plus stock uses a Creality v2.2 board, similar to CR-20 Pro.
# To use this config, the firmware should be compiled for the AVR atmega2560.

# See the example.cfg file for a description of available parameters.

[stepper_x]
step_pin: PF0
dir_pin: PF1
enable_pin: !PD7

imiric

#!/bin/bash
# This replicates xclip functionality used by pass in Cygwin/MSYS2
# Original author: https://tylor.io/2015/07/13/password-manager/

while [[ $# > 0 ]]  
do  
  key="$1"

  case $key in
    -o|-out)

rafi

# github.com/rafi i3status config

# i3status configuration file
# see "man i3status" for documentation.

# It is important that this file is edited as UTF-8.
# The following line should contain a sharp s:
# ß
# If the above line is not correctly displayed, fix your editor first!