e-Gizmo

/*
 * Oscilloscope
 * Gives a visual rendering of analog pin 0 in realtime.
 * 
 * This project is part of Accrochages
 * See http://accrochages.drone.ws
 * 
 * (c) 2008 Sofian Audry (info@sofianaudry.com)
 *
 * This program is free software: you can redistribute it and/or modify

e-Gizmo

/*
 Poor's Man Oscilloscope Arduino Skecth
 
 This is an example code for reading the 
 analog input and to display the value
 signal output on processing.
 
*/

#define ANALOG_IN 0

e-Gizmo

/*
   E-GRA SG-90 SAMPLE CODES
 
 THIS IS A COMPLETE CODE FOR CONTROLLING THE
 ROBOTIC ARM (GRIPPER, ELBOW, SHOULDER, BASE)
 INTERFACE TO GIZDUINO 328 UNO AND KEYPAD.
 OPEN THE SERIAL MONITOR TO SEE THE POSITIONS
 OR DEGREES.
 
 LIBRARY USED:

e-Gizmo

/**********************************************
 * e-Gizmo PBOT2018 Controller - SERVO_SWEEP.ino
 * 
 * This is for SERVO sample sketch
 * to sweeps the shaft back and forth
 * across 180 degrees.
 * 
 * SERVO Control
 * ex. PBOT.SERVO(whichSERVO,pulsewidth);
 * where:

e-Gizmo

/**********************************************
  e-Gizmo PBOT Controller - AVOID COLLISION.ino

  This is for collsion sample sketch to avoid
  crashing on the wall or any objects that blocking
  way of the PBOT.

  Reading the 3channel Collision sensors:

  PBOT.COL1_RIGHT();

e-Gizmo

/**********************************************
  e-Gizmo PBOT2018 Controller - MOTOR_TEST.ino

  This is for motor sample sketch to controls
  and move forward, reverse, turning right,
  turning left, and stop the motors.

  Set motor speed:
  PBOT.SPEED(whichmotor, speed);
  Note: Forward Speed = 0 Full Stop;255 High, limit 250

e-Gizmo

/**********************************************
 * e-Gizmo PBOT2018 Controller - LINEBOT.ino
 * 
 * This is for Linesensor sample sketch to
 * follows the black line or white line track.
 * 
 * Reading the 3channel Line sensors:
 * Calibration Instructions:
 * For the new eGizmo PBOT2017 Controller features
 * first thing to do is to calibrate the line

e-Gizmo

/*
   LM34 Temperature Sensor Sketch
   
   This sample sketch is for LM34 IC
   Temperature Sensor, it can display the
   degrees in Fahrenheit and Celcius.
   
  STEP 1: Construct the circuit of GizDuino Temperature sensor.
  STEP 2: Connect the USB Cable to your computer.
  STEP 3: Open the Arduino IDE.

e-Gizmo

#include <SoftwareSerial.h>

SoftwareSerial mySerial(8, 9); 

void setup()  
{

  Serial.begin(9600);

  Serial.println("Ready for configuration...");

e-Gizmo

////////////////////////////////////////////////
//                                            //
// ON OFF SEQUENCE                            //
//                                            //
// This serves as a sample program for        //
// an LED monitor showing a on off sequence.  //
//                                            // 
//                                            //
// Codes by:                                  //
// eGizmo Mechatronix Central                 //