Created
January 14, 2021 07:54
-
-
Save eisaev/3234e9cd149a2f1c5d89be7b5f923a57 to your computer and use it in GitHub Desktop.
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
[ 0.282380] printk: console [ttyS0] enabled | |
[ 0.282380] printk: console [ttyS0] enabled | |
[ 0.291444] printk: bootconsole [early0] disabled | |
[ 0.291444] printk: bootconsole [early0] disabled | |
[ 0.307880] spi-nor spi0.0: en25qh128 (16384 Kbytes) | |
[ 0.313115] 8 fixed-partitions partitions found on MTD device spi0.0 | |
[ 0.319689] Creating 8 MTD partitions on "spi0.0": | |
[ 0.324647] 0x000000000000-0x000000030000 : "Bootloader" | |
[ 0.331026] 0x000000030000-0x000000040000 : "Nvram" | |
[ 0.336952] 0x000000050000-0x000000060000 : "Bdata" | |
[ 0.342853] 0x000000060000-0x000000070000 : "crash" | |
[ 0.348805] 0x000000070000-0x000000080000 : "art" | |
[ 0.354552] 0x000000070000-0x000000090000 : "cfg_bak" | |
[ 0.360700] 0x000000090000-0x000000200000 : "overlay" | |
[ 0.366780] 0x000000200000-0x000001000000 : "firmware" | |
[ 0.379680] 2 uimage-fw partitions found on MTD device firmware | |
[ 0.385848] Creating 2 MTD partitions on "firmware": | |
[ 0.390989] 0x000000000000-0x000000200000 : "kernel" | |
[ 0.396976] 0x000000200000-0x000000e00000 : "rootfs" | |
[ 0.402929] mtd: device 9 (rootfs) set to be root filesystem | |
[ 0.410542] 1 squashfs-split partitions found on MTD device rootfs | |
[ 0.416995] 0x000000490000-0x000000e00000 : "rootfs_data" | |
[ 0.425236] libphy: Fixed MDIO Bus: probed | |
[ 0.432636] ag71xx 19000000.eth: invalid MAC address, using random address | |
[ 1.068618] libphy: ag71xx_mdio: probed | |
[ 1.075692] switch0: Atheros AR8337 rev. 2 switch registered on mdio.0 | |
[ 1.140242] random: fast init done | |
[ 1.663732] ag71xx 19000000.eth: connected to PHY at mdio.0:00 [uid=004dd036, driver=Atheros AR8216/AR8236/AR8316] | |
[ 1.675000] eth0: Atheros AG71xx at 0xb9000000, irq 4, mode: sgmii | |
[ 1.681629] i2c /dev entries driver | |
[ 1.687307] NET: Registered protocol family 10 | |
[ 1.696552] Segment Routing with IPv6 | |
[ 1.700482] NET: Registered protocol family 17 | |
[ 1.705170] 8021q: 802.1Q VLAN Support v1.8 | |
[ 1.710319] PCI host bridge /ahb/pcie-controller@18250000 ranges: | |
[ 1.716687] MEM 0x0000000012000000..0x0000000013ffffff | |
[ 1.722093] IO 0x0000000000000000..0x0000000000000000 | |
[ 1.727654] PCI host bridge to bus 0000:00 | |
[ 1.731928] pci_bus 0000:00: root bus resource [mem 0x12000000-0x13ffffff] | |
[ 1.739033] pci_bus 0000:00: root bus resource [io 0x0000] | |
[ 1.744791] pci_bus 0000:00: root bus resource [??? 0x00000000 flags 0x0] | |
[ 1.751807] pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff] | |
[ 1.760021] pci 0000:00:00.0: [168c:0046] type 00 class 0x028000 | |
[ 1.766289] pci 0000:00:00.0: reg 0x10: [mem 0x00000000-0x001fffff 64bit] | |
[ 1.773431] pci 0000:00:00.0: PME# supported from D0 D3hot D3cold | |
[ 1.779758] pci 0000:00:00.0: 2.000 Gb/s available PCIe bandwidth, limited by 2.5 GT/s x1 link at 0000:00:00.0 (capable of 4.000 Gb/s with 5 GT/s x1 link) | |
[ 1.794891] pci_bus 0000:00: busn_res: [bus 00-ff] end is updated to 00 | |
[ 1.801771] pci 0000:00:00.0: BAR 0: assigned [mem 0x12000000-0x121fffff 64bit] | |
[ 1.815519] VFS: Mounted root (squashfs filesystem) readonly on device 31:9. | |
[ 1.829490] Freeing unused kernel memory: 1208K | |
[ 1.834190] This architecture does not have kernel memory protection. | |
[ 1.840839] Run /sbin/init as init process | |
[ 2.424080] init: Console is alive | |
[ 2.427909] init: - watchdog - | |
[ 3.212979] kmodloader: loading kernel modules from /etc/modules-boot.d/* | |
[ 3.376487] kmodloader: done loading kernel modules from /etc/modules-boot.d/* | |
[ 3.394376] init: - preinit - | |
[ 4.423366] random: jshn: uninitialized urandom read (4 bytes read) | |
[ 4.670359] random: jshn: uninitialized urandom read (4 bytes read) | |
[ 4.811117] random: jshn: uninitialized urandom read (4 bytes read) | |
[ 5.922386] Atheros AR8216/AR8236/AR8316 mdio.0:00: Port 1 is up | |
[ 5.936975] eth0: link up (1000Mbps/Full duplex) | |
[ 5.950139] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready | |
[ 5.964374] IPv6: ADDRCONF(NETDEV_CHANGE): eth0.1: link becomes ready | |
Press the [f] key and hit [enter] to enter failsafe mode | |
Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level | |
[ 6.001472] urandom_read: 4 callbacks suppressed | |
[ 6.001479] random: procd: uninitialized urandom read (4 bytes read) | |
[ 10.187322] jffs2: notice: (532) jffs2_build_xattr_subsystem: complete building xattr subsystem, 6 of xdatum (0 unchecked, 1 orphan) and 7 of xref (1 dead, 0 orphan) found. | |
[ 10.204641] mount_root: switching to jffs2 overlay | |
[ 10.212862] overlayfs: upper fs does not support tmpfile. | |
[ 10.223705] urandom-seed: Seeding with /etc/urandom.seed | |
[ 10.321452] eth0: link down | |
[ 10.342296] procd: - early - | |
[ 10.345427] procd: - watchdog - | |
[ 10.909788] procd: - watchdog - | |
[ 10.998217] procd: - ubus - | |
[ 11.025577] random: ubusd: uninitialized urandom read (4 bytes read) | |
[ 11.053244] random: ubusd: uninitialized urandom read (4 bytes read) | |
[ 11.061220] procd: - init - | |
Please press Enter to activate this console. | |
[ 11.887755] kmodloader: loading kernel modules from /etc/modules.d/* | |
[ 11.929724] Loading modules backported from Linux version v5.8.18-0-gab435ce49bd1 | |
[ 11.937510] Backport generated by backports.git v5.8.18-1-0-ga630fd46 | |
[ 11.996699] xt_time: kernel timezone is -0000 | |
[ 12.118327] PPP generic driver version 2.4.2 | |
[ 12.133063] NET: Registered protocol family 24 | |
[ 12.213377] urngd: v1.0.2 started. | |
[ 12.229400] ath: phy0: both bands are disabled | |
[ 12.234009] ath: phy0: Unable to initialize hardware; initialization status: -22 | |
[ 12.241660] ath9k 18100000.wmac: failed to initialize device | |
[ 12.247558] ath9k: probe of 18100000.wmac failed with error -22 | |
[ 12.288618] kmodloader: done loading kernel modules from /etc/modules.d/* | |
[ 12.378489] random: crng init done | |
[ 22.707984] eth0: link up (1000Mbps/Full duplex) | |
[ 22.762326] br-lan: port 1(eth0.1) entered blocking state | |
[ 22.767964] br-lan: port 1(eth0.1) entered disabled state | |
[ 22.773845] device eth0.1 entered promiscuous mode | |
[ 22.778835] device eth0 entered promiscuous mode | |
[ 22.784796] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready | |
[ 22.799139] br-lan: port 1(eth0.1) entered blocking state | |
[ 22.804771] br-lan: port 1(eth0.1) entered forwarding state | |
[ 23.724395] IPv6: ADDRCONF(NETDEV_CHANGE): br-lan: link becomes ready | |
BusyBox v1.31.1 () built-in shell (ash) | |
_______ ________ __ | |
| |.-----.-----.-----.| | | |.----.| |_ | |
| - || _ | -__| || | | || _|| _| | |
|_______|| __|_____|__|__||________||__| |____| | |
|__| W I R E L E S S F R E E D O M | |
----------------------------------------------------- | |
OpenWrt SNAPSHOT, r15475-c625c821d1 | |
----------------------------------------------------- | |
=== WARNING! ===================================== | |
There is no root password defined on this device! | |
Use the "passwd" command to set up a new password | |
in order to prevent unauthorized SSH logins. | |
-------------------------------------------------- | |
root@OpenWrt:/# |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment