configuration.nix

{ config, pkgs, ... }:

{
  imports = [ <nixpkgs/nixos/modules/installer/cd-dvd/sd-image-armv7l-multiplatform.nix> ];
}

sd-image-armv7l-multiplatform.nix

# To build, use:
# nix-build nixos -I nixos-config=nixos/modules/installer/cd-dvd/sd-image-armv7l-multiplatform.nix -A config.system.build.sdImage
{ config, lib, pkgs, ... }:

let
  extlinux-conf-builder =
    import ../../system/boot/loader/generic-extlinux-compatible/extlinux-conf-builder.nix {
      inherit pkgs;
    };
in
{
  imports = [
    ../../profiles/base.nix
    ../../profiles/installation-device.nix
    ./sd-image.nix
  ];

  assertions = lib.singleton {
    assertion = pkgs.stdenv.hostPlatform.system == "armv7l-linux"
      && pkgs.stdenv.hostPlatform.system == pkgs.stdenv.buildPlatform.system;
    message = "sd-image-armv7l-multiplatform.nix can be only built natively on ARMv7; " +
      "it cannot be cross compiled";
  };

  boot.loader.grub.enable = false;
  boot.loader.generic-extlinux-compatible.enable = true;

  boot.consoleLogLevel = lib.mkDefault 7;
  boot.kernelPackages = pkgs.linuxPackages_latest;
  # The serial ports listed here are:
  # - ttyS0: for Tegra (Jetson TK1)
  # - ttymxc0: for i.MX6 (Wandboard)
  # - ttyAMA0: for Allwinner (pcDuino3 Nano) and QEMU's -machine virt
  # - ttyO0: for OMAP (BeagleBone Black)
  # - ttySAC2: for Exynos (ODROID-XU3)
  boot.kernelParams = ["console=ttyS0,115200n8" "console=ttymxc0,115200n8" "console=ttyAMA0,115200n8" "console=ttyO0,115200n8" "console=ttySAC2,115200n8" "console=tty0"];

  sdImage = {
    populateBootCommands = let
      configTxt = pkgs.writeText "config.txt" ''
        # Prevent the firmware from smashing the framebuffer setup done by the mainline kernel
        # when attempting to show low-voltage or overtemperature warnings.
        avoid_warnings=1

        [pi2]
        kernel=u-boot-rpi2.bin

        [pi3]
        kernel=u-boot-rpi3.bin

        # U-Boot used to need this to work, regardless of whether UART is actually used or not.
        # TODO: check when/if this can be removed.
        enable_uart=1
      '';
      in ''
        (cd ${pkgs.raspberrypifw}/share/raspberrypi/boot && cp bootcode.bin fixup*.dat start*.elf $NIX_BUILD_TOP/boot/)
        cp ${pkgs.ubootRaspberryPi2}/u-boot.bin boot/u-boot-rpi2.bin
        cp ${pkgs.ubootRaspberryPi3_32bit}/u-boot.bin boot/u-boot-rpi3.bin
        cp ${configTxt} boot/config.txt
        ${extlinux-conf-builder} -t 3 -c ${config.system.build.toplevel} -d ./boot
      '';
  };
}