Skip to content

Instantly share code, notes, and snippets.

@ghostbar
Created January 1, 2010 02:19
Show Gist options
  • Save ghostbar/267015 to your computer and use it in GitHub Desktop.
Save ghostbar/267015 to your computer and use it in GitHub Desktop.
# Most GPRS phones don't reply to LCP echo's
lcp-echo-failure 0
lcp-echo-interval 0
# Keep pppd attached to the terminal:
# Comment this to get daemon mode pppd
nodetach
# Debug info from pppd:
# Comment this off, if you don't need more info
debug
# Show password in debug messages
show-password
# Connect script:
# scripts to initialize the GPRS modem and start the connection,
# wvdial command is for Orange SPV while other phones should work with chat
connect /etc/ppp/peers/gprs-connect-chat
#connect "/usr/bin/wvdial --chat --config /etc/ppp/peers/gprs-wvdial.conf radiolinja_usb_orange_spv"
# Disconnect script:
# AT commands used to 'hangup' the GPRS connection.
disconnect /etc/ppp/peers/gprs-disconnect-chat
# Serial device to which the GPRS phone is connected:
# /dev/ttyS0 for serial port (COM1 in Windows),
# /dev/ircomm0 for IrDA,
# /dev/ttyUB0 for Bluetooth (Bluez with rfcomm running) and
# /dev/ttyUSB0 for USB
#/dev/ttyS0 # serial port one
#/dev/ttyS1 # serial port two
#/dev/ircomm0 # IrDA serial port one
/dev/rfcomm0 # Bluetooth serial port one
#/dev/ttyUSB0 # USB serial device, for example Orange SPV
# Serial port line speed
115200 # fast enough
#57600 # perhaps usefull with IrDA as some phones don't like
# speeds higher than this
# Hardware flow control:
# Use hardware flow control with cable, Bluetooth and USB but not with IrDA.
crtscts # serial cable, Bluetooth and USB, on some occations with IrDA too
#nocrtscts # IrDA
# Ignore carrier detect signal from the modem:
local
# IP addresses:
# - accept peers idea of our local address and set address peer as 10.0.0.1
# (any address would do, since IPCP gives 0.0.0.0 to it)
# - if you use the 10. network at home or something and pppd rejects it,
# change the address to something else
#:169.254.1.1
# pppd must not propose any IP address to the peer!
noipdefault
# Accept peers idea of our local address
ipcp-accept-local
# Add the ppp interface as default route to the IP routing table
defaultroute
# Newer pppd's also support replacing the default route, if one is
# already present, when the GPRS connetion should be set as the default route
# to the network
#replacedefaultroute
# DNS servers from the phone:
# some phones support this, some don't.
usepeerdns
# ppp compression:
# ppp compression may be used between the phone and the pppd, but the
# serial connection is usually not the bottleneck in GPRS, so the
# compression is useless (and with some phones need to disabled before
# the LCP negotiations succeed).
novj
nobsdcomp
novjccomp
nopcomp
noaccomp
# The phone is not required to authenticate:
noauth
# Username and password:
# If username and password are required by the APN, put here the username
# and put the username-password combination to the secrets file:
# /etc/ppp/pap-secrets for PAP and /etc/ppp/chap-secrets for CHAP
# authentication. See pppd man pages for details.
# Example, Radiolinja operator pap-secrets:
# "rlnet" * "internet" *
user ""
# The persist tries to reopen the connection if it is dropped. This
# is usefull for example with a Nokia 7650 which only manages to
# 'dial' with every second attempt or when the network likes to drop the
# connection every now and then. It's not fun when the over-night
# 'apt-get dist-upgrade -d -y' fails constantly...
#persist
#maxfail 99
# Asyncmap:
# some phones may require this option.
#asyncmap 0xa0000
# No magic:
# some phones may require this option.
#nomagic
# Require PAP authentication:
# some phones may require this option.
#require-pap
#!/bin/sh
exec chat \
TIMEOUT 5 \
ECHO ON \
ABORT '\nBUSY\r' \
ABORT '\nERROR\r' \
ABORT '\nNO ANSWER\r' \
ABORT '\nNO CARRIER\r' \
ABORT '\nNO DIALTONE\r' \
ABORT '\nRINGING\r\n\r\nRINGING\r' \
'' \rAT \
TIMEOUT 12 \
SAY "Press CTRL-C to close the connection at any stage!" \
SAY "\ndefining PDP context...\n" \
OK ATH \
OK ATE1 \
OK 'AT+CGDCONT=1,"IP","gprsweb.digitel.ve","",0,0' \
OK ATD*99# \
TIMEOUT 22 \
SAY "\nwaiting for connect...\n" \
CONNECT "" \
SAY "\nConnected." \
SAY "\nIf the following ppp negotiations fail,\n" \
SAY "try restarting the phone.\n"
#!/bin/sh
exec /usr/sbin/chat -V -s -S \
ABORT "BUSY" \
ABORT "ERROR" \
ABORT "NO DIALTONE" \
SAY "\nSending break to the modem\n" \
"" "\K" \
"" "\K" \
"" "\K" \
"" "\d\d+++\d\dATH" \
SAY "\nPDP context detached\n"
Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment