theodric

0. Don't have a SIM card in when you're updating radio firmware or it will bomb out partway through as it changes from internal IP to IP passthrough

1. Disable external IP passthrough mode: Network Setting -> Broadband -> Cellular APN -> #1 -> Modify icon -> "IP Passthrough" slider to off

2. Use "management" Wi-Fi AP as general Wi-Fi AP (with limitations) -> Network Setting -> Bridge1 -> Modify icon -> Move the Wi-Fi AP interface to the pane on the right alongside LAN1
NOTE: by default, once you do the above, the router will happily pass traffic from devices on the Wi-Fi AP to other devices on the LAN1 subnet, but will block traffic originating from the Wi-Fi AP from exiting to the Internet via the LTE side of the device. You can clumsily hack around this by setting another device, e.g. another Wi-Fi AP or Raspberry Pi or Cray supercomputer, as the default gateway for the LAN1 subnet in your DHCP server config, and pointing *that* device at the Zyxel as *its* default GW. This adds additional hops, but enabl

jult

#!/bin/sh

# This script runs every other night at 04:56 CET on a webserver I maintain
# Results are always at: https://jult.net/block.txt ( or https://jult.net/block.txt.gz )
# And much smaller, stripped of BS; https://jult.net/bloc.txt
# For use in Tixati IP filter: https://jult.net/bloc.txt.gz !!!
# And finally a txt file with just the bold IP-ranges: https://jult.net/bl.txt (or https://jult.net/bl.txt.gz )

# Download open block-lists, unpack, filter:
curl -s https://www.iblocklist.com/lists.php | grep -A 2 Bluetack | xargs wget -qO - --limit-rate=500k | gunzip -f | egrep -v '^#' > /tmp/xbp