Configuration of BMP280 Arduino Sensor

BMP280CONFIG

 /////////////////////////////////////////////////////////////////////////////////////////////////////
// BMP280_DEV - I2C Communications (Alternative Address), Default Configuration, Normal Conversion
/////////////////////////////////////////////////////////////////////////////////////////////////////

#include <BMP280_DEV.h>                           // Include the BMP280_DEV.h library

float temperature, pressure, altitude;            // Create the temperature, pressure and altitude variables
BMP280_DEV bmp280;                                // Instantiate (create) a BMP280_DEV object and set-up for I2C operation

void setup() 
{
  Serial.begin(115200);                           // Initialise the serial port
  bmp280.begin(BMP280_I2C_ALT_ADDR);              // Default initialisation with alternative I2C address (0x76), place the BMP280 into SLEEP_MODE 
  //bmp280.setPresOversampling(OVERSAMPLING_X4);    // Set the pressure oversampling to X4
  //bmp280.setTempOversampling(OVERSAMPLING_X1);    // Set the temperature oversampling to X1
  //bmp280.setIIRFilter(IIR_FILTER_4);              // Set the IIR filter to setting 4
  bmp280.setTimeStandby(TIME_STANDBY_2000MS);     // Set the standby time to 2 seconds
  bmp280.startNormalConversion();                 // Start BMP280 continuous conversion in NORMAL_MODE
  bmp280.setSeaLevelPressure(1019.00f);
}

void loop() 
{
  if (bmp280.getMeasurements(temperature, pressure, altitude))    // Check if the measurement is complete
  {
    Serial.print(temperature);                    // Display the results    
    Serial.print(F("*C   "));
    Serial.print(pressure);    
    Serial.print(F("hPa   "));
    Serial.print(altitude);
    Serial.println(F("m"));
  }
}