makcuk

# Simple linux tun/tap device example tunnel over udp
# create tap device with ip tuntap add device0 tap
# set ip address on it and run tap-linux on that device and set desitation ip
# run same on another node, changing dst ip to first node

import fcntl
import struct
import os
import socket
import threading

adtac

#!/usr/bin/env -S bash -c "docker run -p 8080:8080 -it --rm \$(docker build --progress plain -f \$0 . 2>&1 | tee /dev/stderr | grep -oP 'sha256:[0-9a-f]*')"

# syntax = docker/dockerfile:1.4.0

FROM node:20

WORKDIR /root

RUN npm install sqlite3

gbaman

Setting up Pi Zero OTG - The quick way (No USB keyboard, mouse, HDMI monitor needed)

More details - http://blog.gbaman.info/?p=791

For this method, alongside your Pi Zero, MicroUSB cable and MicroSD card, only an additional computer is required, which can be running Windows (with Bonjour, iTunes or Quicktime installed), Mac OS or Linux (with Avahi Daemon installed, for example Ubuntu has it built in).
1. Flash Raspbian Jessie full or Raspbian Jessie Lite onto the SD card.
2. Once Raspbian is flashed, open up the boot partition (in Windows Explorer, Finder etc) and add to the bottom of the config.txt file dtoverlay=dwc2 on a new line, then save the file.
3. If using a recent release of Jessie (Dec 2016 onwards), then create a new file simply called ssh in the SD card as well. By default SSH i

gbaman

Raspberry Pi Zero OTG Mode

Simple guide for setting up OTG modes on the Raspberry Pi Zero - By Andrew Mulholland (gbaman).

The Raspberry Pi Zero (and model A and A+) support USB On The Go, given the processor is connected directly to the USB port, unlike on the B, B+ or Pi 2 B, which goes via a USB hub.
Because of this, if setup to, the Pi can act as a USB slave instead, providing virtual serial (a terminal), virtual ethernet, virtual mass storage device (pendrive) or even other virtual devices like HID, MIDI, or act as a virtual webcam!
It is important to note that, although the model A and A+ can support being a USB slave, they are missing the ID pin (is tied to ground internally) so are unable to dynamically switch between USB master/slave mode. As such, they default to USB master mode. There is no easy way to change this right now.
It is also important to note, that a USB to UART serial adapter is not needed for any of these guides, as may be documented elsewhere across the int