Chimowicz Hillel hllhll

## biqu_bx_klipper.md

      
              1 file
            
          
              3 forks
            
          
              54 comments
            
          
              16 stars
            
          
                adelyser
                / biqu_bx_klipper.md
            
            
              Last active
              February 17, 2024 11:40
            
          
    Klipper on the BIQU BX

So you want to run Klipper on your BIQU BX? Well too bad it's not supported.... but I do have some good news. I have a preliminary branch ready to submit to Klipper to support the BIQU BX. Here's what you need to know in order to get started.
NOTE: If you have a V3 board, click here
_**UPDATE: The Biqu BX is now supported in mainstream klipper!
NOTE: CAN will not work on this board due to a hardware mis-configuration
NOTE: I2C is not quite working yet!

  
## make_current_arm64_rpi_kernel_debs.sh
#!/bin/bash -x
# make_arm64_rpi_kernel_debs.sh
# Builds arm64 debian packages from the CURRENT rpi firmware repository kernel which is installed by:
# sudo rpi-update
# This runs on an arm64 host with arm64 compilation tools...
# or with some sort of cross-compilation setup.
# Debs are put in $workdir/build
#
# This will NOT work in Raspbian unless you have an arm64 compilation
# environment setup. Appears to work on
	#!/bin/bash -x
	# make_arm64_rpi_kernel_debs.sh
	# Builds arm64 debian packages from the CURRENT rpi firmware repository kernel which is installed by:
	# sudo rpi-update
	# This runs on an arm64 host with arm64 compilation tools...
	# or with some sort of cross-compilation setup.
	# Debs are put in $workdir/build
	#
	# This will NOT work in Raspbian unless you have an arm64 compilation
	# environment setup. Appears to work on